Messages in this thread Patch in this message |  | | From | Moritz Fischer <> | Subject | [PATCH] fpga-manager: altera-ps-spi: preserve nCONFIG state | Date | Sun, 15 Apr 2018 11:33:08 -0700 |
| |
From: Anatolij Gustschin <agust@denx.de>
If the driver module is loaded when FPGA is configured, the FPGA is reset because nconfig is pulled low (low-active gpio inited with GPIOD_OUT_HIGH activates the signal which means setting its value to low). Init nconfig with GPIOD_OUT_LOW to prevent this.
Signed-off-by: Anatolij Gustschin <agust@denx.de> Acked-by: Alan Tull <atull@kernel.org> Signed-off-by: Moritz Fischer <mdf@kernel.org> ---
Hi Greg,
as discussed. Can you please take this bugfix for 4.17? I rebased it against next.
Thanks,
Moritz
PS: Sorry for late submission --- drivers/fpga/altera-ps-spi.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/fpga/altera-ps-spi.c b/drivers/fpga/altera-ps-spi.c index 14f14efdf0d5..06d212a3d49d 100644 --- a/drivers/fpga/altera-ps-spi.c +++ b/drivers/fpga/altera-ps-spi.c @@ -249,7 +249,7 @@ static int altera_ps_probe(struct spi_device *spi) conf->data = of_id->data; conf->spi = spi; - conf->config = devm_gpiod_get(&spi->dev, "nconfig", GPIOD_OUT_HIGH); + conf->config = devm_gpiod_get(&spi->dev, "nconfig", GPIOD_OUT_LOW); if (IS_ERR(conf->config)) { dev_err(&spi->dev, "Failed to get config gpio: %ld\n", PTR_ERR(conf->config)); -- 2.17.0
|  |