lkml.org 
[lkml]   [2018]   [Apr]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 6/6] fsl_pmc: update device bindings
Date
From: Li Yang <leoli@freescale.com>

Signed-off-by: Li Yang <leoyang.li@nxp.com>
Signed-off-by: Zhao Chenhui <chenhui.zhao@nxp.com>
Signed-off-by: Ran Wang <ran.wang_1@nxp.com>
---
Changes in v2:
- new file

.../devicetree/bindings/powerpc/fsl/pmc.txt | 59 +++++++++++--------
1 files changed, 34 insertions(+), 25 deletions(-)

diff --git a/Documentation/devicetree/bindings/powerpc/fsl/pmc.txt b/Documentation/devicetree/bindings/powerpc/fsl/pmc.txt
index 07256b7..f1f749f 100644
--- a/Documentation/devicetree/bindings/powerpc/fsl/pmc.txt
+++ b/Documentation/devicetree/bindings/powerpc/fsl/pmc.txt
@@ -9,15 +9,20 @@ Properties:

"fsl,mpc8548-pmc" should be listed for any chip whose PMC is
compatible. "fsl,mpc8536-pmc" should also be listed for any chip
- whose PMC is compatible, and implies deep-sleep capability.
+ whose PMC is compatible, and implies deep-sleep capability and
+ wake on user defined packet(wakeup on ARP).
+
+ "fsl,p1022-pmc" should be listed for any chip whose PMC is
+ compatible, and implies lossless Ethernet capability during sleep.

"fsl,mpc8641d-pmc" should be listed for any chip whose PMC is
compatible; all statements below that apply to "fsl,mpc8548-pmc" also
apply to "fsl,mpc8641d-pmc".

Compatibility does not include bit assignments in SCCR/PMCDR/DEVDISR; these
- bit assignments are indicated via the sleep specifier in each device's
- sleep property.
+ bit assignments are indicated via the clock nodes. Device which has a
+ controllable clock source should have a "fsl,pmc-handle" property pointing
+ to the clock node.

- reg: For devices compatible with "fsl,mpc8349-pmc", the first resource
is the PMC block, and the second resource is the Clock Configuration
@@ -33,31 +38,35 @@ Properties:
this is a phandle to an "fsl,gtm" node on which timer 4 can be used as
a wakeup source from deep sleep.

-Sleep specifiers:
+Clock nodes:
+The clock nodes are to describe the masks in PM controller registers for each
+soc clock.
+- fsl,pmcdr-mask: For "fsl,mpc8548-pmc"-compatible devices, the mask will be
+ ORed into PMCDR before suspend if the device using this clock is the wake-up
+ source and need to be running during low power mode; clear the mask if
+ otherwise.

- fsl,mpc8349-pmc: Sleep specifiers consist of one cell. For each bit
- that is set in the cell, the corresponding bit in SCCR will be saved
- and cleared on suspend, and restored on resume. This sleep controller
- supports disabling and resuming devices at any time.
+- fsl,sccr-mask: For "fsl,mpc8349-pmc"-compatible devices, the corresponding
+ bit specified by the mask in SCCR will be saved and cleared on suspend, and
+ restored on resume.

- fsl,mpc8536-pmc: Sleep specifiers consist of three cells, the third of
- which will be ORed into PMCDR upon suspend, and cleared from PMCDR
- upon resume. The first two cells are as described for fsl,mpc8578-pmc.
- This sleep controller only supports disabling devices during system
- sleep, or permanently.
-
- fsl,mpc8548-pmc: Sleep specifiers consist of one or two cells, the
- first of which will be ORed into DEVDISR (and the second into
- DEVDISR2, if present -- this cell should be zero or absent if the
- hardware does not have DEVDISR2) upon a request for permanent device
- disabling. This sleep controller does not support configuring devices
- to disable during system sleep (unless supported by another compatible
- match), or dynamically.
+- fsl,devdisr-mask: Contain one or two cells, depending on the availability of
+ DEVDISR2 register. For compatible devices, the mask will be ORed into DEVDISR
+ or DEVDISR2 when the clock should be permenently disabled.

Example:

- power@b00 {
- compatible = "fsl,mpc8313-pmc", "fsl,mpc8349-pmc";
- reg = <0xb00 0x100 0xa00 0x100>;
- interrupts = <80 8>;
+ power@e0070 {
+ compatible = "fsl,mpc8536-pmc", "fsl,mpc8548-pmc";
+ reg = <0xe0070 0x20>;
+
+ etsec1_clk: soc-clk@24 {
+ fsl,pmcdr-mask = <0x00000080>;
+ };
+ etsec2_clk: soc-clk@25 {
+ fsl,pmcdr-mask = <0x00000040>;
+ };
+ etsec3_clk: soc-clk@26 {
+ fsl,pmcdr-mask = <0x00000020>;
+ };
};
--
1.7.1
\
 
 \ /
  Last update: 2018-04-11 08:58    [W:0.088 / U:0.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site