lkml.org 
[lkml]   [2018]   [Mar]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] usb: dwc3: Prevent indefinite sleep in _dwc3_set_mode during suspend/resume
From
Date
On 09/03/18 11:23, Felipe Balbi wrote:
>
> Hi,
>
> Roger Quadros <rogerq@ti.com> writes:
>
> <snip>
>
>>>> When we set up the DWC3_DEPCMD_ENDTRANSFER command in
>>>> dwc3_stop_active_transfer(), we can do not set DWC3_DEPCMD_CMDIOC,
>>>> then there will no endpoint command complete interrupts I think.
>>>>
>>>> cmd |= DWC3_DEPCMD_CMDIOC;
>>>
>>> I remember some part of the databook mandating CMDIOC to be set. We
>>> could test it out without and see if anything blows up. I would,
>>> however, require a lengthy comment explaining that we're deviating from
>>> databook revision x.yya, section foobar because $reasons. :-)
>>>
>>
>> This is what the v3.10 databook says
>>
>> "When issuing an End Transfer command, software must set the CmdIOC
>> bit (field 8) so that an Endpoint Command Complete event is generated
>> after the transfer ends. This is necessary to synchronize the
>> conclusion of system bus traffic before the End Transfer command is
>> completed."
>>
>> with a note
>>
>> "If GUCTL2[Rst_actbitlater] is set, Software can poll the completion
>> of the End Transfer command by polling the command active bit to be
>> cleared to 0."
>>
>> fyi.
>>
>> Rst_actbitlater - "Enable clearing of the command active bit for the
>> ENDXFER command after the command execution is completed. This bit is
>> valid in device mode only."
>>
>> So I'd prefer not to clear CMDIOC for all cases.
>>
>> Could we some how just tackle the dwc3_gadget_exit case like I did in
>> this patch?
>
> if you can send a version that doesn't iterate over all endpoints twice,
> sure. We still need a comment somewhere, and I fear we may get
> interrupts later in some cases. How would we deal with that?
>

how about explicitly masking that interrupt? Is it possible?

--
cheers,
-roger

Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki

\
 
 \ /
  Last update: 2018-03-09 10:27    [W:0.074 / U:0.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site