lkml.org 
[lkml]   [2018]   [Mar]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 4/6] phy: qcom-qmp: Add QMP V3 USB3 UNI PHY support for sdm845
From
Date
Hi,


On 3/19/2018 11:21 PM, Evan Green wrote:
> Hi Manu,
>
> On Fri, Mar 16, 2018 at 2:46 AM Manu Gautam <mgautam@codeaurora.org> wrote:
[snip]
>> index d1c6905..5d78d43 100644
>> --- a/drivers/phy/qualcomm/phy-qcom-qmp.h
>> +++ b/drivers/phy/qualcomm/phy-qcom-qmp.h
>> @@ -214,6 +214,8 @@
>> #define QSERDES_V3_RX_UCDR_FASTLOCK_FO_GAIN 0x030
>> #define QSERDES_V3_RX_UCDR_SO_SATURATION_AND_ENABLE 0x034
>> #define QSERDES_V3_RX_RX_TERM_BW 0x07c
>> +#define QSERDES_V3_RX_VGA_CAL_CNTRL1 0x0bc
> I noticed you add this definition, but never use it. Are you missing a
> QMP_PHY_INIT_CFG line for this register in qmp_v3_usb3_uniphy_rx_tbl[], or
> is that register "don't care"? It looks important, and while its default
> value out of reset might be valid, you never know what nutty value boot
> firmware might set it to.
>

Yes POR value of this register is valid for this soc.
QMP driver resets (asserts and de-asserts reset_control) in probe. So, that should
ensure that PHY registers are indeed set to POR value. Left the definition there
if different setting needed to be done for a different variant of h/w in future.

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2018-03-20 08:00    [W:0.049 / U:0.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site