lkml.org 
[lkml]   [2018]   [Mar]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH V2 0/5] mmc: add stm32 sdmmc controller
From
Date


On 03/01/2018 11:44 AM, Ulf Hansson wrote:
> On 1 March 2018 at 10:57, Ludovic BARRE <ludovic.barre@st.com> wrote:
>> Hi Ulf
>>
>> On 03/01/2018 10:06 AM, Ulf Hansson wrote:
>>>
>>> Hi Ludovic,
>>>
>>> On 28 February 2018 at 16:47, Ludovic Barre <ludovic.Barre@st.com> wrote:
>>>>
>>>> From: Ludovic Barre <ludovic.barre@st.com>
>>>>
>>>> This patch serie adds support of stm32 SDMMC controller.
>>>> stm32h7 is the first SoC to use stm32 SDMMC controller
>>>> (previous SoC had pl180 controller).
>>>
>>>
>>> I am a not convinced this isn't a new improved variant of the pl180.
>>> According to register layout and the code you submitted in patch2,
>>> there are great similarities to pl180 and the mmci driver.
>>
>>
>> In fact, ST designers which created stm32-sdmmc hardware block from scratch
>> are the same which have done the modifications on pl180 variant (stm32
>> legacy f4, f7).
>> So some registers or bits name seem identical (or strongly inspirited) but
>> the engine and features are different.
>
> Well, in that case, I assume the driver would also need work
> differently, but when looking at the code in patch2 this doesn't seem
> to be the case.
>

I understand why you push to avoid drivers multiplication. But I'm
scared to squash 2 different hardware block which are their own roadmap
in the same drivers. I fear that it complicates the features management
and maintenance of this driver.

there are some difference:
-the stm32-sdmmc use an internal dma (stm32-sdmmc is master on the bus),
-idma alignment constraint.
-idma transfer mode single buffer, double buffer... (future evolution)
-need a command to stop transmission for data state machine
-same bit naming could have offset, mask width or set in different register.
=> I will try to synthesis register difference in a document
-voltage switch sequence
-delay block: calibration, tunning (sdr104)
-reset line required
-the same feature have not the same impact, example ddr mode
stm32:no bypass clk, activated in clk register
pl180: clkreg_neg_edge_enable, activated in datactrl register,
...

stm32-sdmmc is just at begining of its life cycle. Each revision of this
block increases the difference with pl180. Today, I've just push the
minimal driver to start a request, but I've not yet send all features of
this revision like sdio, sdr104 support. After this revision there
already are 2 other revisions in the pipe (at short term).

I am Out of Office with limited access to my e-mail till 2018 march 12th
I'll try to think about it on ski slope. euh, in fact no just ski and
enjoy ;-)

BR
Ludo

>>
>> You could find the datasheet of STM32H7x3 on:
>> http://www.st.com/content/ccc/resource/technical/document/reference_manual/group0/c9/a3/76/fa/55/46/45/fa/DM00314099/files/DM00314099.pdf/jcr:content/translations/en.DM00314099.pdf
>>
>> Chapters: 55 Secure digital input/output MultiMediaCard interface
>> (SDMMC)
>
> Thanks for sharing this. However this confirms my view, it looks
> exactly as a new improved mmci variant. :-)
>
>>
>> This hardware block has own roadmap and some features are already in the
>> pipe for next SoC.
>
> That's fine. I don't have a problem extending the mmci driver, even
> several times, as to cope with new revisions.
>
>>
>> For code design: like I also worked on pl180 in the past :-)
>> my code is inspirited of this driver.
>
> Right, that may explain things a bit.
>
> However, besides a re-name of the registers, I really think that the
> code execution, dealing with IRQs etc, is very similar to the mmci
> driver. Isn't it?
>
> So, I think it's at least worth to give it a go with the mmci driver
> first, to see if we can get it to work.
>
> I guess you understand why I am pushing!? This is about maintenance -
> and I really want to avoid having a yet another driver to maintain,
> unless we can extend an existing one.
>
> [...]
>
> Kind regards
> Uffe
>

\
 
 \ /
  Last update: 2018-03-02 12:20    [W:2.210 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site