lkml.org 
[lkml]   [2018]   [Mar]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 2/6] mmc: dw_mmc: remove the deprecated "num-slots"
On 23 February 2018 at 07:41, Jaehoon Chung <jh80.chung@samsung.com> wrote:
> 'num-slots' property had already deprecated.
> Remove the 'nom-slots' property that is kept to maintain the compatibility.
>
> Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com>

Thanks, applied for next!

Kind regards
Uffe

> ---
> Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt | 5 -----
> drivers/mmc/host/dw_mmc-pci.c | 1 -
> drivers/mmc/host/dw_mmc.c | 4 ----
> drivers/mmc/host/dw_mmc.h | 3 ---
> 4 files changed, 13 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt
> index 75c9fdca4aaf..7e5e427a22ce 100644
> --- a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt
> +++ b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt
> @@ -59,11 +59,6 @@ Optional properties:
> is specified and the ciu clock is specified then we'll try to set the ciu
> clock to this at probe time.
>
> -* num-slots (DEPRECATED): specifies the number of slots supported by the controller.
> - The number of physical slots actually used could be equal or less than the
> - value specified by num-slots. If this property is not specified, the value
> - of num-slot property is assumed to be 1.
> -
> * fifo-depth: The maximum size of the tx/rx fifo's. If this property is not
> specified, the default value of the fifo size is determined from the
> controller registers.
> diff --git a/drivers/mmc/host/dw_mmc-pci.c b/drivers/mmc/host/dw_mmc-pci.c
> index ab8713297edb..3ad07d7b2c97 100644
> --- a/drivers/mmc/host/dw_mmc-pci.c
> +++ b/drivers/mmc/host/dw_mmc-pci.c
> @@ -29,7 +29,6 @@
> MMC_CAP_SDIO_IRQ)
>
> static struct dw_mci_board pci_board_data = {
> - .num_slots = 1,
> .caps = DW_MCI_CAPABILITIES,
> .bus_hz = 33 * 1000 * 1000,
> .detect_delay_ms = 200,
> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
> index 38e0e7c4ffd9..a63ca7bc1099 100644
> --- a/drivers/mmc/host/dw_mmc.c
> +++ b/drivers/mmc/host/dw_mmc.c
> @@ -3124,10 +3124,6 @@ static struct dw_mci_board *dw_mci_parse_dt(struct dw_mci *host)
> return ERR_PTR(-EPROBE_DEFER);
> }
>
> - /* find out number of slots supported */
> - if (!device_property_read_u32(dev, "num-slots", &pdata->num_slots))
> - dev_info(dev, "'num-slots' was deprecated.\n");
> -
> if (device_property_read_u32(dev, "fifo-depth", &pdata->fifo_depth))
> dev_info(dev,
> "fifo-depth property not found, using value of FIFOTH register as default\n");
> diff --git a/drivers/mmc/host/dw_mmc.h b/drivers/mmc/host/dw_mmc.h
> index e3124f06a47e..80ff9a6c6fdd 100644
> --- a/drivers/mmc/host/dw_mmc.h
> +++ b/drivers/mmc/host/dw_mmc.h
> @@ -102,7 +102,6 @@ struct dw_mci_dma_slave {
> * @bus_hz: The rate of @mck in Hz. This forms the basis for MMC bus
> * rate and timeout calculations.
> * @current_speed: Configured rate of the controller.
> - * @num_slots: Number of slots available.
> * @fifoth_val: The value of FIFOTH register.
> * @verid: Denote Version ID.
> * @dev: Device associated with the MMC controller.
> @@ -253,8 +252,6 @@ struct dma_pdata;
>
> /* Board platform data */
> struct dw_mci_board {
> - u32 num_slots;
> -
> unsigned int bus_hz; /* Clock speed at the cclk_in pad */
>
> u32 caps; /* Capabilities */
> --
> 2.15.1
>

\
 
 \ /
  Last update: 2018-03-15 11:25    [W:0.134 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site