[lkml]   [2018]   [Mar]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 0/2] Introduce STM32MP1 Reset driver
Hi Philipp,

Okay, i too support the idea to add custom  reset driver.

Many Thanks Philipp.

Best regards


On 03/14/2018 10:12 AM, Philipp Zabel wrote:
> Hi Gabriel,
> On Tue, 2018-03-13 at 17:34 +0100, wrote:
>> From: Gabriel Fernandez <>
>> This patch-set enables the reset of STM32MP1.
>> It uses the reset simple driver by introducing the clear register offset
>> parameter.
>> STM32MP1 reset IP has a register to assert by writing '1' and another
>> register to de-assert by writing '1'.
>> The offset between this two registers is '0x4'.
> I worry a bit about feature creep in the simple-reset driver.
> Your patch on its own is simple enough, and I'm not opposed to add a
> SET/CLR feature on principle, but there are a few issues:
> The RESET_SIMPLE Kconfig description currently says:
>   "This enables a simple reset controller driver for reset lines that
>    that can be asserted and deasserted by toggling bits in a contiguous,
>    exclusive register space."
> That would have to be extended to mention SET/CLR register pairs as an
> alternative.
> What about status (reset_simple_status)? Can current reset line status
> be read back from the SET register, as is currently tried? If not, is
> there a way to read current reset line status back at all?
> The data->lock spinlock is only needed to protect the read-modify-write
> cycle on a toggle register, for separate SET/CLR register access the
> locking is not necessary.
> At this point, it may or may not be easier to add a custom reset driver.
> Either way you go, this is missing binding documentation for the
> st,stm32mp1-rcc compatible in Documentation/devicetree/bindings/reset.
>> The patch 'dt-bindings: reset: add STM32MP1 resets' could be squashed
>> with the patch:
>> 'dt-bindings: Document STM32MP1 Reset Clock Controller (RCC) bindings'
>> commit 3830681d354f
>> Gabriel Fernandez (2):
>> dt-bindings: reset: add STM32MP1 resets
>> reset: simple: Enable stm32mp1 reset driver
>> drivers/reset/reset-simple.c | 27 +++++--
>> drivers/reset/reset-simple.h | 1 +
>> include/dt-bindings/reset/stm32mp1-resets.h | 108 ++++++++++++++++++++++++++++
>> 3 files changed, 130 insertions(+), 6 deletions(-)
>> create mode 100644 include/dt-bindings/reset/stm32mp1-resets.h
> regards
> Philipp
 \ /
  Last update: 2018-03-14 10:43    [W:0.054 / U:1.712 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site