lkml.org 
[lkml]   [2018]   [Feb]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] serial: 8250: Don't service RX FIFO if interrupts are disabled
Date
Currently, data in RX FIFO is read based on UART_LSR register state even
if RDI and RLSI interrupts are disabled in UART_IER register.
This is because when IRQ handler is called due to TX FIFO empty event,
RX FIFO is serviced based on UART_LSR register status instead of
UART_IIR status. This defeats the purpose of disabling UART RX
FIFO interrupts during throttling(see, omap_8250_throttle()) as IRQ
handler continues to drain UART RX FIFO resulting in overflow of buffer
at tty layer.
Fix this by making sure that driver drains UART RX FIFO only when
UART_IIR_RDI is set along with UART_LSR_BI or UART_LSR_DR bits.

Signed-off-by: Vignesh R <vigneshr@ti.com>
---
drivers/tty/serial/8250/8250_port.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/tty/serial/8250/8250_port.c b/drivers/tty/serial/8250/8250_port.c
index 1328c7e70108..ffbb955d1c06 100644
--- a/drivers/tty/serial/8250/8250_port.c
+++ b/drivers/tty/serial/8250/8250_port.c
@@ -1854,7 +1854,8 @@ int serial8250_handle_irq(struct uart_port *port, unsigned int iir)

status = serial_port_in(port, UART_LSR);

- if (status & (UART_LSR_DR | UART_LSR_BI)) {
+ if (status & (UART_LSR_DR | UART_LSR_BI) &&
+ iir & UART_IIR_RDI) {
if (!up->dma || handle_rx_dma(up, iir))
status = serial8250_rx_chars(up, status);
}
--
2.16.1
\
 
 \ /
  Last update: 2018-02-08 13:56    [W:0.047 / U:0.496 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site