Messages in this thread | | | Date | Tue, 6 Feb 2018 10:10:57 +0100 | From | Maxime Ripard <> | Subject | Re: [PATCH v2 07/10] ARM: sun8i: h3: add SY8113B regulator used by Orange Pi One board |
| |
On Tue, Feb 06, 2018 at 12:49:02PM +0800, Icenowy Zheng wrote: > Orange Pi One board has a SY8113B regulator, which is controlled via > GPIO and capable of outputing 1.1V when the PL6 GPIO is set to output 0 > or 1.3V when the PL6 GPIO is set to input or output 1, and the output is > the power supply of the ARM cores in H3 SoC. > > Add the device tree node of this regulator and set the cpu's cpu-supply > property to it. > > Signed-off-by: Icenowy Zheng <icenowy@aosc.io> > --- > New patch in v2. > > arch/arm/boot/dts/sun8i-h3-orangepi-one.dts | 21 +++++++++++++++++++++ > 1 file changed, 21 insertions(+) > > diff --git a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts > index 82e5d28cd698..d8250aacfda1 100644 > --- a/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts > +++ b/arch/arm/boot/dts/sun8i-h3-orangepi-one.dts > @@ -88,6 +88,27 @@ > gpios = <&r_pio 0 3 GPIO_ACTIVE_LOW>; > }; > }; > + > + reg_sy8113b: gpio-regulator {
There's multiple of them on those boards, so the name and label should avoid conflicting names (this also applies to your other patches).
Maxime
-- Maxime Ripard, Bootlin (formerly Free Electrons) Embedded Linux and Kernel engineering http://bootlin.com [unhandled content-type:application/pgp-signature] | |