Messages in this thread | | | Date | Mon, 5 Feb 2018 00:08:59 -0600 | From | Rob Herring <> | Subject | Re: [PATCH v3 2/2] ARM: dts: imx25-pinfunc: Always set SION for eSDHC CMD |
| |
On Wed, Jan 31, 2018 at 10:35:44PM +0100, Benoît Thébaudeau wrote: > The eSDHC does not work properly if the SION bit is not set for the > bidirectional CMD signal, whatever the eSDHC instance and the selected > pad. Therefore, setting SION is mandatory for all eSDHC CMD ports. Do > this for MX25_PAD_*__ESDHCn_CMD in imx25-pinfunc.h in order to enforce > this behavior for all boards. > > This had already been done for eSDHC1, but not for eSDHC2. Also, define > MX25_PAD_FEC_MDC__ESDHC2_CMD so that all the possible cases are covered > from now on. > > Cc: Uwe Kleine-König <u.kleine-koenig@pengutronix.de> > Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau.dev@gmail.com> > Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com> > --- > Changes v2 -> v3: > - Quickly mention SION in each comment, besides the reference to the > verbose comment (suggested by Uwe). > Changes v1 -> v2: > - Update eSDHC instance and port naming following the addition of "ARM: > dts: imx25-pinfunc: Use consistent naming for eSDHC". > - Reference the more verbose comment for MX25_PAD_SD1_CMD__ESDHC1_CMD > instead of copying the same less detailed comment everywhere > (suggested by Uwe). > --- > arch/arm/boot/dts/imx25-pinfunc.h | 18 +++++++++++------- > 1 file changed, 11 insertions(+), 7 deletions(-)
Reviewed-by: Rob Herring <robh@kernel.org>
| |