lkml.org 
[lkml]   [2018]   [Feb]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v5 6/9] watchdog/hpwdt: remove allow_kdump module parameter.
Date
The intent of this parameter is unclear and it sets up a
race between the reset of the system by ASR and crashdump.

The length of time between receipt of the pretimeout NMI
and the ASR reset of the system is fixed by hardware.

Turning the parameter off doesn't necessairly prevent a crash dump.
Also, having the ASR reset occur while the system is crash dumping
doesn't imply that the dump was hung given the short duration
between the NMI and the reset.

This parameter is not a substitute for having a architected watchdog
crashdump hang detection paridigm.

Signed-off-by: Jerry Hoemann <jerry.hoemann@hpe.com>
---
drivers/watchdog/hpwdt.c | 16 +++-------------
1 file changed, 3 insertions(+), 13 deletions(-)

diff --git a/drivers/watchdog/hpwdt.c b/drivers/watchdog/hpwdt.c
index 171d5033d7b5..68e84a212d00 100644
--- a/drivers/watchdog/hpwdt.c
+++ b/drivers/watchdog/hpwdt.c
@@ -36,9 +36,6 @@ static bool ilo5;
static unsigned int soft_margin = DEFAULT_MARGIN; /* in seconds */
static unsigned int reload; /* the computed soft_margin */
static bool nowayout = WATCHDOG_NOWAYOUT;
-#ifdef CONFIG_HPWDT_NMI_DECODING
-static unsigned int allow_kdump = 1;
-#endif

static void __iomem *pci_mem_addr; /* the PCI-memory address */
static unsigned long __iomem *hpwdt_nmistat;
@@ -124,8 +121,7 @@ static int hpwdt_pretimeout(unsigned int ulReason, struct pt_regs *regs)
if (ilo5 && ulReason == NMI_UNKNOWN && mynmi)
return NMI_DONE;

- if (allow_kdump)
- hpwdt_stop();
+ hpwdt_stop();

hex_byte_pack(panic_msg, mynmi);
nmi_panic(regs, panic_msg);
@@ -186,9 +182,8 @@ static int hpwdt_init_nmi_decoding(struct pci_dev *dev)
goto error2;

dev_info(&dev->dev,
- "HPE Watchdog Timer Driver: NMI decoding initialized"
- ", allow kernel dump: %s (default = 1/ON)\n",
- (allow_kdump == 0) ? "OFF" : "ON");
+ "HPE Watchdog Timer Driver: NMI decoding initialized\n");
+
return 0;

error2:
@@ -322,9 +317,4 @@ module_param(nowayout, bool, 0);
MODULE_PARM_DESC(nowayout, "Watchdog cannot be stopped once started (default="
__MODULE_STRING(WATCHDOG_NOWAYOUT) ")");

-#ifdef CONFIG_HPWDT_NMI_DECODING
-module_param(allow_kdump, int, 0);
-MODULE_PARM_DESC(allow_kdump, "Start a kernel dump after NMI occurs");
-#endif /* CONFIG_HPWDT_NMI_DECODING */
-
module_pci_driver(hpwdt_driver);
--
2.13.6
\
 
 \ /
  Last update: 2018-02-26 04:24    [W:0.082 / U:0.392 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site