lkml.org 
[lkml]   [2018]   [Dec]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 06/12] dt-bindings: PCI: aardvark: Describe the reset-gpios property
Date
A GPIO might be used to reset the PCI IP. Describe the property needed
in this case.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Reviewed-by: Rob Herring <robh@kernel.org>
---
Documentation/devicetree/bindings/pci/aardvark-pci.txt | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/pci/aardvark-pci.txt b/Documentation/devicetree/bindings/pci/aardvark-pci.txt
index 310ef7145c47..252934237138 100644
--- a/Documentation/devicetree/bindings/pci/aardvark-pci.txt
+++ b/Documentation/devicetree/bindings/pci/aardvark-pci.txt
@@ -20,6 +20,10 @@ contain the following properties:
define the mapping of the PCIe interface to interrupt numbers.
- bus-range: PCI bus numbers covered

+The following are optional properties:
+
+ - reset-gpios: GPIO to reset the device
+
In addition, the Device Tree describing an Aardvark PCIe controller
must include a sub-node that describes the legacy interrupt controller
built into the PCIe controller. This sub-node must have the following
@@ -48,6 +52,7 @@ Example:
<0 0 0 2 &pcie_intc 1>,
<0 0 0 3 &pcie_intc 2>,
<0 0 0 4 &pcie_intc 3>;
+ reset-gpios = <&gpiosb 3 GPIO_ACTIVE_HIGH>;
pcie_intc: interrupt-controller {
interrupt-controller;
#interrupt-cells = <1>;
--
2.19.1
\
 
 \ /
  Last update: 2018-12-12 11:23    [W:0.094 / U:0.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site