Messages in this thread Patch in this message | | | From | Sasha Levin <> | Subject | [PATCH AUTOSEL 4.19 45/73] net: phy: micrel: add toggling phy reset if PHY is not attached | Date | Wed, 12 Dec 2018 23:28:10 -0500 |
| |
From: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
[ Upstream commit 8c85f4b81296a530b8af2796c110fa482ac42d4f ]
This patch adds toggling phy reset if PHY is not attached. Otherwise, some boards (e.g. R-Car H3 Salvator-XS) cannot link up correctly if we do the following method:
1) Kernel boots by using initramfs. --> No open the nic, so phy_device_register() and phy_probe() deasserts the reset. 2) Kernel enters the suspend. --> So, keep the reset signal as deassert. --> On R-Car Salvator-XS board, unfortunately, the board power is turned off. 3) Kernel returns from suspend. 4) ifconfig eth0 up --> Then, since edge signal of the reset doesn't happen, it cannot link up. 5) ifconfig eth0 down 6) ifconfig eth0 up --> In this case, it can link up.
Reported-by: Hiromitsu Yamasaki <hiromitsu.yamasaki.ym@renesas.com> Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com> Signed-off-by: David S. Miller <davem@davemloft.net> Signed-off-by: Sasha Levin <sashal@kernel.org> --- drivers/net/phy/micrel.c | 8 ++++++++ 1 file changed, 8 insertions(+)
diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c index 3db06b40580d..327f00034d01 100644 --- a/drivers/net/phy/micrel.c +++ b/drivers/net/phy/micrel.c @@ -23,6 +23,7 @@ * ksz9477 */ +#include <linux/delay.h> #include <linux/kernel.h> #include <linux/module.h> #include <linux/phy.h> @@ -725,6 +726,13 @@ static int kszphy_resume(struct phy_device *phydev) { int ret; + if (!phydev->attached_dev) { + /* If the PHY is not attached, toggle the reset */ + phy_device_reset(phydev, 1); + udelay(1); + phy_device_reset(phydev, 0); + } + genphy_resume(phydev); ret = kszphy_config_reset(phydev); -- 2.19.1
| |