lkml.org 
[lkml]   [2018]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH REGRESSION] Revert "ath10k: add quiet mode support for QCA6174/QCA9377"
On 2018-11-08 09:30, Brian Norris wrote:
> On Wed, Nov 7, 2018 at 8:32 PM Govind Singh <govinds@codeaurora.org>
> wrote:
>> On 2018-11-08 03:00, Rajkumar Manoharan wrote:
>> >
>> > The change "ath10k: add quiet mode support for QCA6174/QCA9377" was
>> > merged even
>> > before full WCN3990 device support was added in ath10k. How come it
>> > could be regression
>> > for WCN3990. I know both are sharing same WMI-TLV interface but
>> > reverting this
>> > will break QCA6174/QCA9377. no?
>
> I don't see how the revert would "break" QCA6174 -- QCA6174 worked
> just fine without this feature and should continue to do so.
>

I meant that the revert commit remove quiet mode support from QCA6174 &
QCA9377.

>> This regression is found while we switched from 4.18 + WCN3990
>> back-ports to 4.19.
>
> ^^ What Govind said. WCN3990 support has been trickling in over a few
> releases, and it doesn't seem kosher to allow people to submit
> regressions in the midst of that.
>
Nobody prefers regression :). WCN3990 support was still in progress, at
the time the commit got merged into upstream. My point is that we can't
expect
the community to validate the changes against in-progress platform.

>>
>> IMO, we should use (WMI_SERVICE_THERMAL_MGMT | WMI_SERVICE_THERM_THROT
>> )
>> service bitmap check and call
>> ath10k_thermal_set_throttling only if fw supports THERMAL THROTTLE
>> feature. But we need to ensure all
>> available ath10k fw's are reporting this service.
>
> And the above notes from Govind highlight this -- if the feature was
> not protected by the appropriate service flags, then we can't be sure
> that you didn't break a bunch of other firmware releases out there.
> Linux should not break for everyone just because you spun a firmware
> release.
>
That is true. Any new features or interface changes in firmware will be
advertised by feature bit. But the quiet param was available in firmware
since first release.

> Of course, I'll leave it up to Kalle as to how he wants to mediate
> this. And if you come up with a solid patch soon that can fix this
> without dropping the feature, then so be it.
>
Govind is working on to handle this properly either by instantiating
new WMI-TLV table for WCNxxxx or by adding conditional check in exiting
path.

-Rajkumar

\
 
 \ /
  Last update: 2018-11-08 20:53    [W:0.064 / U:0.188 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site