lkml.org 
[lkml]   [2018]   [Nov]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3] ARM: dts: imx6sx-sdb: Fix enet phy regulator
On Mon, Oct 08, 2018 at 03:28:01PM +0000, Leonard Crestez wrote:
> Bindings for "fixed-regulator" only explicitly support "gpio" property,
> not "gpios". Fix by correcting the property name.
>
> The enet PHYs on imx6sx-sdb needs to be explicitly reset after a power
> cycle, this can be handled by the phy-reset-gpios property. Sadly this
> is not handled on suspend: the fec driver turns phy-supply off but
> doesn't assert phy-reset-gpios again on resume.
>
> Since additional phy-level work is required to support powering off the
> phy in suspend fix the problem by just marking the regulator as
> "boot-on" "always-on" so that it's never turned off. This behavior is
> equivalent to older releases.
>
> Keep the phy-reset-gpios property on fec anyway because it is a correct
> description of board design.
>
> This issue was exposed by commit efdfeb079cc3 ("regulator: fixed:
> Convert to use GPIO descriptor only") which causes the "gpios" property
> to also be parsed. Before that commit the "gpios" property had no
> effect, PHY reset was only handled in the the bootloader.
>
> This fixes linux-next boot failures previously reported here:
> https://lore.kernel.org/patchwork/patch/982437/#1177900
> https://lore.kernel.org/patchwork/patch/994091/#1178304
>
> Signed-off-by: Leonard Crestez <leonard.crestez@nxp.com>

Applied, thanks.

\
 
 \ /
  Last update: 2018-11-05 03:18    [W:0.053 / U:0.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site