lkml.org 
[lkml]   [2018]   [Nov]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH] ARM: multi_v7_defconfig: switch CONFIG_PWM_MESON to built-in
Date
Martin Blumenstingl <martin.blumenstingl@googlemail.com> writes:

> Hi Kevin,
>
> On Thu, Nov 29, 2018 at 1:30 AM Kevin Hilman <khilman@baylibre.com> wrote:
>>
>> Martin Blumenstingl <martin.blumenstingl@googlemail.com> writes:
>>
>> > Some Meson8b boards (Odroid-C1, EC-100) use a PWM regulator which is the
>> > voltage supply of the CPU cores (this regulator is typically called
>> > "VCCK").
>> > Now that we are preparing support for CPU frequency scaling on Meson8,
>> > Meson8b and Meson8m2 we should build the pwm-meson driver into the
>> > kernel so we can configure the CPU voltage early in the boot process.
>>
>> Can you explain a little more why the configuration of CPU voltage
>> cannot wait a bit so this could be properly probed?
>
> I was under the impression that cpufreq-dt would still initialize even
> if the regulator is not ready yet. however (after reading the code
> again) this is clearly NOT the case.

Hmm, a quick look at cpufreq-dt suggests that it should -EPROBE_DEFER if
the regulator isn't ready yet. Why doesn't that work?

> there's still a benefit with this change: your Odroid-C1 in your
> KernelCI lab would also be able to change the CPU frequency (so in
> case something breaks we could spot it there).
> will you accept this patch after I updated the description to mention
> that it's for KernelCI test coverage?

Possibly, but I'd still rather see the dependencies worked out correctly
so that this can be module, and cpufreq-dt would defer until it's ready.

Kevin

\
 
 \ /
  Last update: 2018-11-30 00:29    [W:0.046 / U:0.612 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site