lkml.org 
[lkml]   [2018]   [Nov]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 1/4] net: macb: Check MDIO state before read/write and use timeouts
Hi Claudiu,
On Mon, Nov 26, 2018 at 8:22 PM Andrew Lunn <andrew@lunn.ch> wrote:
>
> On Mon, Nov 26, 2018 at 02:46:01PM +0000, Claudiu.Beznea@microchip.com wrote:
> > Hi Harini,
> >
> > On 26.11.2018 09:07, Harini Katakam wrote:
> > > From: Harini Katakam <harinik@xilinx.com>
> > >
> > > Replace the while loop in MDIO read/write functions with a timeout.
> > > In addition, add a check for MDIO bus busy before initiating a new
> > > operation as well to make sure there is no ongoing MDIO operation.
> >
> > Is this MDIO bus busy check necessary? The caller of
> > macb_mdio_read/macb_mdio_write locks the mdio bus mutex before calling it
> > (e.g. mdiobus_read).
>
> Hi Claudiu
>
> It depends on the implementation. A write operation you could just
> launch, but not wait for it to complete, allowing you to do other
> stuff while the hardware is busy. For the next operation you then do
> need to check the previous operation has completed.
>
> I've not checked it is actually implemented this way.

Yes, as Andrew mentioned, a previous MDIO bus operation cannot
be assumed to be complete always - for ex., in case of a timeout.
There is a chance that the MDIO bus bit is busy when mdio_read/write
is called.

Regards,
Harini

\
 
 \ /
  Last update: 2018-11-27 06:38    [W:0.119 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site