lkml.org 
[lkml]   [2018]   [Nov]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/2] irq/irq_sim: provide irq_sim_fire_edge()
Hello Bartosz,

On Wed, Nov 21, 2018 at 05:34:32PM +0100, Bartosz Golaszewski wrote:
> wt., 20 lis 2018 o 18:17 Uwe Kleine-König
> <u.kleine-koenig@pengutronix.de> napisał(a):
> >
> > On Tue, Nov 20, 2018 at 02:40:31PM +0100, Bartosz Golaszewski wrote:
> > > From: Bartosz Golaszewski <bgolaszewski@baylibre.com>
> > >
> > > The irq_sim irqchip doesn't allow to configure the sensitivity so every
> > > call to irq_sim_fire() fires a dummy interrupt. This used to not matter
> > > for gpio-mockup (one of the irq_sim users) until commit fa38869b0161
> > > ("gpiolib: Don't support irq sharing for userspace") which made it
> > > impossible for gpio-mockup to ignore certain events (e.g. only receive
> > > notifications about rising edge events).
> > >
> > > Introduce a specialized variant of irq_sim_fire() which takes another
> > > argument called edge. allowing to specify the trigger type for the
> > > dummy interrupt.
> >
> > I wonder if it's worth the effort to fix irq_sim. If you take a look in
> > my gpio-simulator patch, it is trivial to get it right without external
> > help with an amount of code that is usual for a driver that handles
> > irqs.
>
> You're basically recommending handcrafting another local piece of code
> for simulating interrupts - something that multiple users may be
> interested in. You did that in your proposed gpio-simulator and I
> still can't understand why you couldn't reuse the existing solution.
> Even if it's broken for your use-case, it's surely easier to fix it
> than to rewrite and duplicate it? There are very few cases where code
> consolidation is not a good thing and I don't think this is one of
> them.

I don't say that factoring out common stuff is bad. But if in the end
you call

irq_sim_something(some, parameters, offset);

with the simulator and if you don't use the irq simulator you do

irq = irq_find_mapping(irqdomain, offset);
generic_handle_irq(irq);

I prefer the latter because it's only a single additional line and in
return it's more obvious what it does because it's the same that many
other drivers (for real hardware) also do.

Best regards
Uwe

--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |

\
 
 \ /
  Last update: 2018-11-21 20:19    [W:0.142 / U:0.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site