lkml.org 
[lkml]   [2018]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC PATCH v2 01/17] OPP: Allow to request stub voltage regulators
From
Date
On 10/24/18 9:41 AM, Viresh Kumar wrote:
> On 22-10-18, 15:12, Dmitry Osipenko wrote:
>> Because there is one Tegra20 board (tegra20-trimslice) that doesn't declare
>> necessary regulators, but we want to have CPU frequency scaling. I couldn't
>> find board schematics and so don't know if CPU / CORE voltages are fixed on
>> Trim-Slice or it is just preferable not to have DVFS for that board, it is an
>> outlet-powered device [0]. Hence tegra20-cpufreq driver will request a dummy
>> regulators when appropriate.
>
> We have been using the regulator_get_optional() variant until now in the OPP
> core to make sure that we don't do DVFS for the CPU without the mandatory
> regulators being present, as that may make things unstable and cause harm to the
> SoC if we try to take CPU to frequency range over the currently programmed
> regulator can support.
>
> Now coming back to tegra-20 SoC, which actually requires a regulator normally by
> design. On one of the boards (which is outlet powered), you aren't sure if there
> is a programmable regulator or not, or if DVFS should really be done or not.
> Isn't it worth checking the same from Tegra maintainers, or whomsoever has
> information on that board ?

I'll try to find out more detailed information for the next revision of the patchset.

What would happen if there actually was a regulator
> and its default settings aren't good enough for high end frequencies ?

Usually this causes kernel/applications crashes and/or machine hang.

> On the other hand, the tegra20 cpufreq driver is common across a lot of boards.
> What will happen if the DT for some of the boards isn't correct and missed the
> necessary regulator node ?

AFAIK, there is assumption that bootloader should setup regulators in a way that kernel could work properly at max clock rates. Otherwise things won't work.

And because you are moving to regulator_get() API for
> the entire SoC (i.e. its cpufreq driver), people will never find the missing
> regulator.

Regulators core prints info message when dummy regulator is being used.

> If we can do it safely for all tegra20 boards, why not migrate to using
> regulator_get() instead of regulator_get_optional() in the OPP core API itself
> for everyone ?
>

This should be a platform-specific decision. For Tegra we know that regulators should be in a good state at kernel boot time, I don't think that this applies to other platforms.

\
 
 \ /
  Last update: 2018-10-26 14:04    [W:0.607 / U:0.224 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site