Messages in this thread | | | Date | Fri, 12 Oct 2018 18:23:16 +0530 | From | Himanshu Jha <> | Subject | Re: [PATCH v4 3/3] iio: magnetometer: Add driver support for PNI RM3100 |
| |
Hi Qiang,
On Fri, Oct 12, 2018 at 04:36:01PM +0800, Song Qiang wrote: > > > On 2018年10月12日 15:35, Song Qiang wrote: > > PNI RM3100 is a high resolution, large signal immunity magnetometer, > > composed of 3 single sensors and a processing chip with a MagI2C > > interface. > > > ... > > +static irqreturn_t rm3100_trigger_handler(int irq, void *p) > > +{ > > + struct iio_poll_func *pf = p; > > + struct iio_dev *indio_dev = pf->indio_dev; > > + unsigned long scan_mask = *indio_dev->active_scan_mask; > > + unsigned int mask_len = indio_dev->masklength; > > + struct rm3100_data *data = iio_priv(indio_dev); > > + struct regmap *regmap = data->regmap; > > + int ret, i, bit; > > + > > + mutex_lock(&data->lock); > > + switch (scan_mask) { > > + case BIT(0) | BIT(1) | BIT(2): > > + ret = regmap_bulk_read(regmap, RM3100_REG_MX2, data->buffer, 9); > > + mutex_unlock(&data->lock); > > + if (ret < 0) > > + goto done; > > + break; > > + case BIT(0) | BIT(1): > > + ret = regmap_bulk_read(regmap, RM3100_REG_MX2, data->buffer, 6); > > + mutex_unlock(&data->lock); > > + if (ret < 0) > > + goto done; > > + break; > > + case BIT(1) | BIT(2): > > + ret = regmap_bulk_read(regmap, RM3100_REG_MY2, data->buffer, 6); > > + mutex_unlock(&data->lock); > > + if (ret < 0) > > + goto done; > > + break; > Hi Jonathan, > > I just noticed that these three breaks are not proper aligned.
Please send the new version of a patch as a *new* thread and don't use `--in-reply-to` flag(if you're using) to chain into older versions as whole thread of older discussion comes up and is often not required.
The changelog gives enough info of what's new in the revised series.
-- Himanshu Jha Undergraduate Student Department of Electronics & Communication Guru Tegh Bahadur Institute of Technology
| |