Messages in this thread Patch in this message | | | From | David Wu <> | Subject | [PATCH 2/2] pinctrl: rockchip: Fix the correct routing config for the gmac-m1 pins of rmii and rgmii | Date | Sat, 30 Sep 2017 20:13:21 +0800 |
| |
If the gmac-m1 optimization(bit10) is selected, the gpio function of gmac pins is not valid. We may use the rmii mode for gmac interface, the pins such as rx_d2, rx_d3, which the rgmii mode used, but rmii not used could be taken as gpio function. So gmac_rxd0m1 selects the bit2, and gmac_rxd0m3 select bit10 is more correct.
Signed-off-by: David Wu <david.wu@rock-chips.com> --- drivers/pinctrl/pinctrl-rockchip.c | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-)
diff --git a/drivers/pinctrl/pinctrl-rockchip.c b/drivers/pinctrl/pinctrl-rockchip.c index c7c9beb..9e0cabf 100644 --- a/drivers/pinctrl/pinctrl-rockchip.c +++ b/drivers/pinctrl/pinctrl-rockchip.c @@ -900,12 +900,19 @@ static void rockchip_get_recalced_mux(struct rockchip_pin_bank *bank, int pin, .route_offset = 0x50, .route_val = BIT(16) | BIT(16 + 1) | BIT(0), }, { - /* gmac-m1-optimized_rxd0 */ + /* gmac-m1_rxd0 */ .bank_num = 1, .pin = 11, .func = 2, .route_offset = 0x50, - .route_val = BIT(16 + 2) | BIT(16 + 10) | BIT(2) | BIT(10), + .route_val = BIT(16 + 2) | BIT(2), + }, { + /* gmac-m1-optimized_rxd3 */ + .bank_num = 1, + .pin = 14, + .func = 2, + .route_offset = 0x50, + .route_val = BIT(16 + 10) | BIT(10), }, { /* pdm_sdi0m0 */ .bank_num = 2, -- 1.9.1
| |