Messages in this thread | | | From | Romain Izard <> | Date | Wed, 20 Sep 2017 10:30:31 +0200 | Subject | Re: [PATCH v2 8/9] atmel_flexcom: Support backup mode |
| |
2017-09-19 17:25 GMT+02:00 Lee Jones <lee.jones@linaro.org>: > On Tue, 19 Sep 2017, Nicolas Ferre wrote: > >> On 15/09/2017 at 16:04, Romain Izard wrote: >> > The controller used by a flexcom module is configured at boot, and left >> > alone after this. As the configuration will be lost after backup mode, >> > restore the state of the flexcom driver on resume. >> > >> > Signed-off-by: Romain Izard <romain.izard.pro@gmail.com> >> >> Tested-by: Nicolas Ferre <nicolas.ferre@microchip.com> >> On sama5d2 Xplained board (i2c0 from flexcom 4). >> and obviously: >> Acked-by: Nicolas Ferre <nicolas.ferre@microchip.com> >> >> Thanks Romain! >> >> Regards, >> >> > --- >> > drivers/mfd/atmel-flexcom.c | 65 ++++++++++++++++++++++++++++++++++----------- >> > 1 file changed, 50 insertions(+), 15 deletions(-) > > This is the first time I've seen this patch. Why's that? >
As the patchset covers many subsystems, get_maintainers.pl provided a very long list of both developpers and mailing lists (28). I thought it was a good idea to shorten it a little. Bad idea. Sorry.
Best regards, -- Romain Izard
| |