lkml.org 
[lkml]   [2017]   [Aug]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v3 2/5] reset: socfpga: use the reset-simple driver
From
Date
On Wed, 2017-08-16 at 13:46 -0700, Alexandru Gagniuc wrote:
> Hi Phillip,
>
> On 08/16/2017 02:46 AM, Philipp Zabel wrote:
> [snip]
> > @@ -118,8 +151,23 @@ static int reset_simple_probe(struct
> > platform_device *pdev)
> >   data->rcdev.ops = &reset_simple_ops;
> >   data->rcdev.of_node = dev->of_node;
> >
> > - if (devdata)
> > + if (devdata) {
> > + u32 reg_offset = devdata->reg_offset;
> > +
> > + if (reg_offset &&
> > +     of_property_read_u32(dev->of_node,
> > "altr,modrst-offset",
> > +  &reg_offset)) {
> > + dev_warn(dev,
> > +  "missing altr,modrst-offset
> > property, assuming 0x%x!\n",
> > +  reg_offset);
> > + }
>
> I would not make reading dt properties dependent on the presence of 
> devdata. That breaks being able to configure the reset controller from 
> dt. I would either just read the "altr,modrst-offset" property, or read 
> it when
>
> of_device_is_compatible(dev->of_node, "altr,rst-mgr"));

Checking the compatible again is unnecessary, we already have obtained
devdata depending on the compatible value. I had effectively the same
check in v2:

if (devdata == &reset_simple_socfpga)

I can change back to that, if you prefer. Note that the

if (devdata)
reg_offset = devdata->reg_offset;

part has to stay now that reg_offset is stored in devdata.

> Ideally, we could have a more generic "reg-offset" binding for new reset 
> controllers, but that is beyond the scope of this patch.

Agreed.

regards
Philipp

\
 
 \ /
  Last update: 2017-08-21 10:46    [W:0.041 / U:0.552 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site