lkml.org 
[lkml]   [2017]   [Aug]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] i2c: slave-eeprom: Add an OF device ID table
From
Date
Hello Wolfram,

On 08/14/2017 09:52 PM, Wolfram Sang wrote:
> On Wed, Aug 09, 2017 at 12:12:56PM +0200, Javier Martinez Canillas wrote:
>> The driver doesn't have a struct of_device_id table but supported devices
>> are registered via Device Trees as shown in the following DT binding doc:
>>
>> Documentation/devicetree/bindings/i2c/i2c-designware.txt
>
> Uhhh, that needs to be fixed to something else! I don't think i2c slave
> functionality should be described in DT. The slave functionality is pure
> software, so IMO it doesn't match the "HW description" requirement.
>

Right, indeed.

>> But this works on the assumption that a I2C device registered via OF will
>> always match a legacy I2C device ID and that the MODALIAS reported will
>> always be of the form i2c:<device>.
>>
>> And this could change in the future so the correct approach is to have an
>> OF device ID table if the devices are registered via OF.
>>
>> Signed-off-by: Javier Martinez Canillas <javierm@redhat.com>
>
> Thanks for finding the issue, still NAK to this patch. Are you
> interested in updating the docs?
>

What kind of change are you looking for? The example was introduced by commit
04606ccc84e3 ("i2c: designware: introducing I2C_SLAVE definitions") that says:

- A example was added to designware-core.txt Documentation that shows
how the slave can be setup using DTS

So I could change this example to instead use a real EEPROM compatible (e.g:
"microchip,24c02") instead of "linux,slave-24c02". Would that be correct?

Best regards,
--
Javier Martinez Canillas
Software Engineer - Desktop Hardware Enablement
Red Hat

\
 
 \ /
  Last update: 2017-08-16 11:37    [W:0.054 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site