lkml.org 
[lkml]   [2017]   [Jul]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 5/9] ARM: sun8i: a83t: Add device node and pinmux setting for RSB controller
Date
The A83T has an RSB controller for talking to the PMIC and audio codec.
Add a device node for it. Since there is only one usable pinmux setting,
for it, add that as well.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
arch/arm/boot/dts/sun8i-a83t.dtsi | 23 +++++++++++++++++++++++
1 file changed, 23 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-a83t.dtsi b/arch/arm/boot/dts/sun8i-a83t.dtsi
index d9b4372dbdf3..61304761e8f6 100644
--- a/arch/arm/boot/dts/sun8i-a83t.dtsi
+++ b/arch/arm/boot/dts/sun8i-a83t.dtsi
@@ -47,6 +47,7 @@
#include <dt-bindings/clock/sun8i-a83t-ccu.h>
#include <dt-bindings/clock/sun8i-r-ccu.h>
#include <dt-bindings/reset/sun8i-a83t-ccu.h>
+#include <dt-bindings/reset/sun8i-r-ccu.h>

/ {
interrupt-parent = <&gic>;
@@ -379,6 +380,28 @@
#gpio-cells = <3>;
interrupt-controller;
#interrupt-cells = <3>;
+
+ r_rsb_pins: r-rsb-pins {
+ pins = "PL0", "PL1";
+ function = "s_rsb";
+ drive-strength = <20>;
+ bias-pull-up;
+ };
+ };
+
+ r_rsb: rsb@1f03400 {
+ compatible = "allwinner,sun8i-a83t-rsb",
+ "allwinner,sun8i-a23-rsb";
+ reg = <0x01f03400 0x400>;
+ interrupts = <GIC_SPI 39 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&r_ccu CLK_APB0_RSB>;
+ clock-frequency = <3000000>;
+ resets = <&r_ccu RST_APB0_RSB>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&r_rsb_pins>;
+ status = "disabled";
+ #address-cells = <1>;
+ #size-cells = <0>;
};
};
};
--
2.13.3
\
 
 \ /
  Last update: 2017-07-26 10:30    [W:0.060 / U:3.152 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site