lkml.org 
[lkml]   [2017]   [Mar]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 2/2] can: spi: hi311x: Add Holt HI-311x CAN driver
From
Date
Hello Akshay,

Am 17.03.2017 um 19:28 schrieb Akshay Bhat:
> Hi Wolfgang,
>
> On 03/17/2017 01:04 PM, Wolfgang Grandegger wrote:
>>
>> Hm, that's unusual. Cable disconnected and then send a message:
>>
>> $ grep /proc/interrupts; sleep 10; /proc/interrupts
>>
>> should make things clear. But maybe it's a clever chip and it does stop
>> sending error messages if the error counter does not change any more.
>> After bus-off, the chip is quiet, of course. Should have a closer look
>> to the CAN standard.
>>
>
> The interrupt count does not increment after device reaches
> tx-error-passive (with cable disconnected).
>
> # while true; do grep -i hi3110 /proc/interrupts; sleep 10; done &
> [1] 793
> #
> 111: 0 0 gpio-mxc 12 Edge hi3110
> # candump -t d -e any,0:0,#FFFFFFF &
> [2] 798
> # cansend can0 123#
> #
> (000.000000) can0 20000004 [8] 00 08 00 00 00 00 60 00 ERRORFRAME
> controller-problem{tx-error-warning}
> error-counter-tx-rx{{96}{0}}
> (000.002122) can0 20000004 [8] 00 20 00 00 00 00 80 00 ERRORFRAME
> controller-problem{tx-error-passive}
> error-counter-tx-rx{{128}{0}}
> 111: 10 0 gpio-mxc 12 Edge hi3110
> 111: 10 0 gpio-mxc 12 Edge hi3110
> 111: 10 0 gpio-mxc 12 Edge hi3110

OK, then there is no good reason connecting the STAT interrupt pin.

Wolfgang.

\
 
 \ /
  Last update: 2017-03-18 13:32    [W:0.862 / U:0.192 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site