lkml.org 
[lkml]   [2017]   [Nov]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v7 12/13] slimbus: qcom: Add runtime-pm support using clock-pause
On Wed, Nov 15, 2017 at 02:10:42PM +0000, srinivas.kandagatla@linaro.org wrote:
> From: Sagar Dharia <sdharia@codeaurora.org>
>
> Slimbus HW mandates that clock-pause sequence has to be executed
> before disabling relevant interface and core clocks.
> Runtime-PM's autosuspend feature is used here to enter/exit low
> power mode for Qualcomm's Slimbus controller. Autosuspend feature
> enables driver to avoid changing power-modes too frequently since
> entering clock-pause is an expensive sequence
>
> Signed-off-by: Sagar Dharia <sdharia@codeaurora.org>
> Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
> ---
> +
> +#ifdef CONFIG_PM_SLEEP
> +static int qcom_slim_suspend(struct device *dev)
> +{
> + int ret = 0;
> +
> + if (!pm_runtime_enabled(dev) ||
> + (!pm_runtime_suspended(dev))) {
> + dev_dbg(dev, "system suspend");
> + ret = qcom_slim_runtime_suspend(dev);
> + }
> +
> + /*
> + * If the clock pause failed due to active channels, there is
> + * a possibility that some audio stream is active during suspend.
> + * (e.g. modem usecase during suspend)
> + * We dont want to return suspend failure in that case so that
> + * display and relevant components can still go to suspend.
> + * If there is some other error, then it should prevent
> + * system level suspend
> + */
> + if (ret == -EISCONN)
> + ret = 0;

Who actually returns the EISCONN for this to catch? Or will that
be added to slim_ctrl_clk_pause once support for the audio
channels is added?

Thanks,
Charles

> +
> + return ret;
> +}

\
 
 \ /
  Last update: 2017-11-23 11:19    [W:0.212 / U:1.708 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site