lkml.org 
[lkml]   [2017]   [Oct]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] ARM: dts: exynos: add cpu perf counters to Exynos54xx boards
On Sat, Oct 21, 2017 at 05:54:31PM +1030, Marian Mihailescu wrote:
> Hi Robin,
>
> Apologies, I did not really check which cluster is described for the
> 5410 (since 5422 boots from the A7).
>
> Should I define both pmu nodes (w/o interrupt affinity) in the
> exynos54xx,dtsi, and set the status property to "disabled"?
> And then add the interrupt affinity to the SoC variant, and enable
> them as required...

After putting it under common exynos54xx you would have to anyway
override/extend most of the nodes so I think there is no much sense for
that. Instead it should be in exynos5410.dtsi and exynos5422.dtsi.

>
> The problem that I see however is that, while 5410 is easy to deal
> with (it has the cpus defined in exynos5420.dtsi for all boards), 542x
> variants have the cpus included in the board dts. So there would be
> the same pmu nodes with interrupt affinity copied in all 542x and 5800
> boards dts (and there are several of them), instead of being included
> in exynos542x.dtsi...

You mean exynos5420-cpus.dtsi, not board DTS?

For exynos542x/5800 you could indeed add it directly to
exynos542x-cpus.dtsi, following existing pattern about cpus (with
comment).


Best regards,
Krzysztof

\
 
 \ /
  Last update: 2017-10-22 17:51    [W:0.071 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site