lkml.org 
[lkml]   [2017]   [Jan]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] clk: qcom: gdsc: Fix handling of hw control enable/disable
From
Date
Hi,

Thanks for the patch!

On 23.01.2017 06:26, Rajendra Nayak wrote:
> Once a gdsc is brought in and out of HW control, there is a
> power down and up cycle which can take upto 1us. Polling on
> the gdsc status immediately after the hw control enable/disable
> can mislead software/firmware to belive the gdsc is already either on
> or off, while its yet to complete the power cycle.
> To avoid this add a 1us delay post a enable/disable of HW control
> mode.
>
> Also after the HW control mode is disabled, poll on the status to
> check gdsc status reflects its 'on' before force disabling it
> in software.
>
> Reported-by: Stanimir Varbanov <stanimir.varbanov@linaro.org>
> Signed-off-by: Rajendra Nayak <rnayak@codeaurora.org>
> ---
> drivers/clk/qcom/gdsc.c | 58 ++++++++++++++++++++++++++++++++++++++-----------
> 1 file changed, 45 insertions(+), 13 deletions(-)

Reviewed and Tested-by: Stanimir Varbanov <stanimir.varbanov@linaro.org>

regards,
Stan

\
 
 \ /
  Last update: 2017-01-26 22:40    [W:0.044 / U:0.576 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site