Messages in this thread | | | Date | Wed, 11 May 2016 11:19:15 +0200 | Subject | Re: [PATCH 6/6] pinctrl: tegra: Add driver to configure voltage and power state of io pads | From | Linus Walleij <> |
| |
On Mon, May 2, 2016 at 2:17 PM, Laxman Dewangan <ldewangan@nvidia.com> wrote:
> NVIDIA Tegra210 supports the IO pads which can operate at 1.8V > or 3.3V I/O voltage levels. Also the IO pads can be configured > for power down state if it is not used. SW needs to configure the > voltage level of IO pads based on IO rail voltage and its power > state based on platform usage. > > The voltage and power state configurations of pads are provided > through pin control frameworks. Add pin control driver for Tegra's > IO pads' voltage and power state configurations. > > Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com> > > --- > Changes from V1: > - Use the generic pincontrol property for low power enable/disable. > - sync with latest and remove all MODULE* macros > - Use renamed APIs form PMC
Looks OK to me, need Stephen's ACK though!
Yours, Linus Walleij
| |