lkml.org 
[lkml]   [2016]   [Feb]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v3 1/2] gpio: designware: switch device node to fwnode
From
On Thu, Feb 25, 2016 at 1:58 PM, Jiang Qiu <qiujiang@huawei.com> wrote:
> 在 2016/2/24 21:46, Andy Shevchenko 写道:
>> On Wed, Feb 24, 2016 at 2:33 PM, qiujiang <qiujiang@huawei.com> wrote:

>> - why do you use fwnode_*() instead of device_property_*() calls?
>> What prevents us to move to device property API directly?
> Yes, it looks more reasonable by using devce_property. Howerver,
> device_get_child_node_count was used here to find each child node. This
> API output the fwnode_handle for each child node directly, but device
> property APIs need 'dev' data instead. Actually, the effects of fwnode_*()
> and device_*() are the same. So, I used fwnode_*() APIs here.

Right, looks okay then.

>>> - node = dev->of_node;
>>> - if (!IS_ENABLED(CONFIG_OF_GPIO) || !node)
>>> + if (!IS_ENABLED(CONFIG_OF_GPIO) || !(dev->of_node))
>>> return ERR_PTR(-ENODEV);
>>
>> So, since you converted to fwnode, do you still need this check?
>>
> Although this patch coverted device node to fwnode, only DTs binding was
> supported here, and patch2 support ACPI will remove this check.

Yes, but like I said below device_get_child_node_count() will take
care of that, will it?

>>>
>>> - nports = of_get_child_count(node);
>>> + nports = device_get_child_node_count(dev);
>>> if (nports == 0)
>>> return ERR_PTR(-ENODEV);
>>
>> ...I think this one fail if it will not found any child.
> This one fail? yes, it will return to failure.
> I am not very clear here.

See above.

--
With Best Regards,
Andy Shevchenko

\
 
 \ /
  Last update: 2016-02-25 15:21    [W:0.078 / U:0.656 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site