lkml.org 
[lkml]   [2016]   [Dec]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC PATCH 0/3] Add a new flag for ITS device to control indirect route
From
Date
On 05/12/16 03:11, majun (Euler7) wrote:
> Hi Marc:
>
> 在 2016/12/2 17:35, Marc Zyngier 写道:
>> On 02/12/16 09:29, majun (Euler7) wrote:
>>>
>>>
>>> 在 2016/12/1 17:07, Marc Zyngier 写道:
>>>> On 01/12/16 07:45, Majun wrote:
>>>>> From: MaJun <majun258@huawei.com>
>>>>>
>>>>> For current ITS driver, two level table (indirect route) is enabled when the memory used
>>>>> for LPI route table over the limit(64KB * 2) size. But this function impact the
>>>>> performance of LPI interrupt actually because need more time to look up the table.
>>>>
>>>> Are you implying that your ITS doesn't have a cache to lookup the most
>>>> active devices, hence performing a full lookup on each interrupt?
>>>
>>> Our ITS chip has the cache with depth 64. But this seems not enough for some
>>> scenario,espeically on virtulization platform.
>>
>> Then I don't see how switching to to flat tables is going to improve
>> things. Can you share actual performance numbers?
>>
> Sorry, I run this code on EMU and have no actual performance numbers now.

So how can you make a decision on what is obviously an optimization for
a given use case?

> Suppose there are 66 devices in system.
> As far as our chip concerned, there are always 2 devices can't benefit from
> cache fully when they report the interrupt.
>
> If i'm wrong, please correct me.

Congratulations, you've just discovered one the limitations of *any*
cache. If your miss rate is too high, then your cache is too small (or
your replacement policy is suboptimal). Switching to flat tables is
going to slightly reduce the miss latency (one read less), but is not
going to improve the miss rate.

I'd suggest you talk to your HW people so that they give you either a
bigger cache or a better replacement policy. Or even put fewer devices
in front of your ITS so that you won't miss in the cache, assuming that
your interrupt latency is so critical that you can't miss once in a
while (which I very seriously doubt).

Thanks,

M.
--
Jazz is not dead. It just smells funny...

\
 
 \ /
  Last update: 2016-12-05 10:09    [W:0.061 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site