lkml.org 
[lkml]   [2016]   [Dec]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v4 3/5] i2c: designware: Add slave definitions
On Mon, Dec 12, 2016 at 12:35 PM, Luis de Oliveira
<Luis.Oliveira@synopsys.com> wrote:
> Hi all,

Please don't top post.

>
> The slave address could be set by the I2C slave backend so I can't use it to setup the controller.
> A boolean property was my initial approach then Andy and Wolfram Sang suggested the use of compatible strings and later It was suggested to use a property to select mode but I can do it again if it's the best way.
> Can you please tell me where should it be documented?

bindings/i2c/i2c.txt.

Actually, looking at this some more, we already have a way to describe
the controller being a slave device with the I2C_OWN_SLAVE_ADDRESS
flag in the reg property. We should just need a helper to read reg
property of each child and check for the bit set.

Rob

\
 
 \ /
  Last update: 2016-12-13 00:17    [W:0.064 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site