Messages in this thread | | | Date | Fri, 21 Oct 2016 23:46:11 +0200 | From | Boris Brezillon <> | Subject | Re: [v7, 1/3] nand: pl353: Add basic driver for arm pl353 smc nand interface |
| |
On Fri, 21 Oct 2016 14:33:22 -0600 Jason Gunthorpe <jgunthorpe@obsidianresearch.com> wrote:
> On Mon, Jun 08, 2015 at 11:38:36PM +0530, Punnaiah Choudary Kalluri wrote: > > Add driver for arm pl353 static memory controller nand interface with > > HW ECC support. This controller is used in xilinx zynq soc for interfacing > > the nand flash memory. > > > > Signed-off-by: Punnaiah Choudary Kalluri <punnaia@xilinx.com> > > Changes in v7: > > - Currently not implemented the memclk rate adjustments. I will > > look into this later and once the basic driver is accepted. > > - Fixed GPL licence ident > > Changes in v6: > > - Fixed the checkpatch.pl reported warnings > > - Using the address cycles information from the onfi param page > > earlier it is hardcoded to 5 in driver > > Changes in v5: > > - Configure the nand timing parameters as per the onfi spec > > Changes in v4: > > - Updated the driver to sync with pl353_smc driver APIs > > Changes in v3: > > - implemented the proper error codes > > - further breakdown this patch to multiple sets > > - added the controller and driver details to Documentation section > > - updated the licenece to GPLv2 > > - reorganized the pl353_nand_ecc_init function > > Changes in v2: > > - use "depends on" rather than "select" option in kconfig > > - remove unused variable parts > > - remove dummy helper and use writel_relaxed directly > > What is the status of getting this driver merged? I am interested in > this driver and can provide some help if there are still TODO items.
I'll try to review it next week.
> > At the very least I will test it, is there something newer than v7 out > there? > > Regards, > Jason > > ______________________________________________________ > Linux MTD discussion mailing list > http://lists.infradead.org/mailman/listinfo/linux-mtd/
| |