lkml.org 
[lkml]   [2015]   [Sep]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [linux-sunxi] Re: [PATCH 5/5] ARM: sun5i: Add C.H.I.P DTS
From
Date
Hi,

On 22-09-15 14:57, Chen-Yu Tsai wrote:
> On Tue, Sep 22, 2015 at 8:47 PM, Maxime Ripard
> <maxime.ripard@free-electrons.com> wrote:

<snip>

>>>> +&usb_otg {
>>>> + dr_mode = "otg";
>>>> + status = "okay";
>>>> +};
>>>> +
>>>> +&usbphy {
>>>> + pinctrl-names = "default";
>>>> + pinctrl-0 = <&chip_id_det_pin>;
>>>> + status = "okay";
>>>> +
>>>> + usb0_id_det-gpio = <&pio 6 2 GPIO_ACTIVE_HIGH>; /* PG2 */
>>>
>>> Better leave a comment here saying VBUS detection requires AXP209
>>> usb-power-supply support.
>>
>> Does it? It can be powered by a battery, with or without VBUS, and
>> that wouldn't be tied to the fact that the power-supply is USB or
>> something else.
>
> The AXP209 VBUS / USB power-supply also doubles for VBUS detection,
> which on most boards is done using a separate GPIO pin. Hans posted
> support for the AXP20X power-supply driver, and support in the usb
> phy driver using it for VBUS detection.

Ack.

> In short, this is not about "power supply" but VBUS detection. IIRC,
> if no VBUS detection method is provided, the phy driver just waits a
> period of time after an ID pin change and then considers VBUS invalid.

Right, but that is a hack for boards with no / broken vbus detection
(or vbus control), we really want to use vbus-det where available,
so I agree that a TODO comment here would be good.

Regards,

Hans


\
 
 \ /
  Last update: 2015-09-22 15:21    [W:0.075 / U:0.324 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site