Messages in this thread | | | Subject | Re: [PATCH v3 1/5] Documentation: add DT bindings for ARM SCPI sensors | From | "Jon Medhurst (Tixy)" <> | Date | Mon, 14 Sep 2015 18:18:12 +0100 |
| |
On Mon, 2015-09-14 at 15:38 +0100, Punit Agrawal wrote: > Mark Rutland <mark.rutland@arm.com> writes: > > >> >> +Sensor bindings for the sensors based on SCPI Message Protocol > >> >> +-------------------------------------------------------------- > >> >> +SCPI provides an API to access the various sensors on the SoC. > >> >> + > >> >> +Required properties: > >> >> +- compatible : should be "arm,scpi-sensors". > >> >> +- #thermal-sensor-cells: should be set to 1. This property follows the > >> >> + thermal device tree bindings[2]. > >> > > >> > You need to specify what the valid values for this cell are. > >> > >> The enumeration depends on the number of sensors exported by SCP > >> firmware - which is platform dependent. I could add add something like > >> if you think that is helpful - > >> > >> "Valid cell value is a number between 0..n-1, where n is the number > >> of sensors exported by SCP firmware." > > > > Can the FW identifer space have holes? Or are they always contiguous? > > The way the SCP interface is defined, the sensor identifiers are > contiguous,
Is there any documentation other than DUI0922A? [1] From what I can seen that just says it's a 16-bit value and doesn't put any particular constraints on its value.
[1] http://community.arm.com/servlet/JiveServlet/download/8401-40-18262/DUI0922A_scp_message_interface.pdf
-- Tixy
| |