lkml.org 
[lkml]   [2015]   [Aug]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/7] tty: core: Add tty_debug() for printk(KERN_DEBUG) messages
On 07/23/2015 09:35 PM, Greg Kroah-Hartman wrote:
> On Sun, Jul 12, 2015 at 10:49:08PM -0400, Peter Hurley wrote:
>> Introduce tty_debug() macro to output uniform debug information for
>> tty core debug messages (function name and tty name).
>>
>> Note: printk(KERN_DEBUG) is retained here over pr_debug() since
>> messages can be enabled in non-DEBUG builds.
>
> But pr_debug() is the "standard" way to enable/disable debugging
> messages, so I'd really like to see that be used here.

Ok, I can do that; I'll roll Joe's suggestions in at that time.

> Even better, this is a tty device, so it should be using dev_dbg(),
> which gives us tons of good information built-in for the tty and can
> properly be parsed by userspace tools to know exactly what device caused
> what message at what point in time.
>
> So I'll take this for now, but moving it to use dev_dbg() would be best
> eventually.

The issue with using dev_dbg is that (SysV) ptys are not devices. However,
if you'd prefer, I could rework this macro to format output like dev_dbg;
ie., <driver> <tty name>: <fmt>

Regards,
Peter Hurley


\
 
 \ /
  Last update: 2015-08-05 21:01    [W:0.148 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site