lkml.org 
[lkml]   [2015]   [Jul]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v2 2/5] Documentation: mtd: add a DT property to set the number of dummy cycles
Date
On Wednesday, July 22, 2015 at 03:17:07 PM, Cyrille Pitchen wrote:
> Depending on the SPI clock frequency, the Fast Read op code and the
> Single/Dual Data Rate mode, the number of dummy cycles can be tuned to
> improve transfer speed.
> The actual number of dummy cycles is specific for each memory model and is
> provided by the manufacturer thanks to the memory datasheet.
>
> Signed-off-by: Cyrille Pitchen <cyrille.pitchen@atmel.com>
> ---
> Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
> b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt index
> 2bee68103b01..4387567d8024 100644
> --- a/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
> +++ b/Documentation/devicetree/bindings/mtd/jedec,spi-nor.txt
> @@ -19,6 +19,11 @@ Optional properties:
> all chips and support for it can not be detected at
> runtime. Refer to your chips' datasheet to check if this is supported by
> your chip.
> +- m25p,num-dummy-cycles : Set the number of dummy cycles for Fast Read
> commands. + Depending on the manufacturer
> additional dedicated + commands are sent to the
> flash memory so the + controller and the memory
> can agree on the number of + dummy cycles to use.

Can't you just try negotiating this value at probe time, starting with some
high value and see how low you can get with the negotiations ? This way, you'd
be able to effectively auto-detect this value at probe-time.

I might be wrong though :)

Best regards,
Marek Vasut


\
 
 \ /
  Last update: 2015-07-22 16:21    [W:0.166 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site