lkml.org 
[lkml]   [2015]   [Jul]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] ARM: DTS: am437x-sk-evm: Switch using simple-audio-card for audio support
On Thu, Jul 02, 2015 at 03:52:49PM +0300, Peter Ujfalusi wrote:
> On 07/02/2015 03:23 PM, Felipe Balbi wrote:
> > On Thu, Jul 02, 2015 at 02:58:06PM +0300, Peter Ujfalusi wrote:
> >> The sound support consist only Headset output on the board and can be
> >> handled by "simple-audio-card"
> >>
> >> Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
> >
> > Still works fine:
> >
> > Tested-by: Felipe Balbi <balbi@ti.com>
> >
> > one question though, should Line In be listed below ?
>
> Does the board have Line-in? I don't have the board, but I know this patch

yeah, it does :-)

> works on it ;)
> We only had playback path before also.

indeed, should go for -next only :-s

> > Also, unrelated to
> > $subject, but if I wait for a few seconds between runs of speaker-test
> > (iow, if I allow mcasp to idle) then I hear a slight chopping sound when
> > starting, perhaps we're unmuting too early ?
>
> Is it only with this patch (via simple-card) or was it the same via the
> davinci-evm (ti,da830-evm-audio)?

/me goes test again

also without this patch :-)

--
balbi
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2015-07-02 15:41    [W:0.040 / U:2.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site