lkml.org 
[lkml]   [2015]   [Jul]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v1 1/3] gpio: defer probe if pinctrl cannot be found
On 07/10/2015 10:21 AM, Tomeu Vizoso wrote:
> On 10 July 2015 at 17:27, Stephen Warren <swarren@wwwdotorg.org> wrote:
>> On 07/10/2015 03:29 AM, Tomeu Vizoso wrote:
>>>
>>> On 1 July 2015 at 19:36, Rob Herring <robherring2@gmail.com> wrote:
>>>>
>>>> On Wed, Jul 1, 2015 at 7:45 AM, Tomeu Vizoso <tomeu.vizoso@collabora.com>
>>>> wrote:
>>>>>
>>>>> When an OF node has a pin range for its GPIOs, return -EPROBE_DEFER if
>>>>> the pin controller isn't available.
>>>>>
>>>>> Otherwise, the GPIO range wouldn't be set at all unless the pin
>>>>> controller probed always before the GPIO chip.
>>>>>
>>>>> With this change, the probe of the GPIO chip will be deferred and will
>>>>> be retried at a later point, hopefully once the pin controller has been
>>>>> registered and probed already.
>>>>
>>>>
>>>> This will break cases where the pinctrl driver does not exist, but the
>>>> DT contains pinctrl bindings. We can have similar problems already
>>>> with clocks though. However, IMO this problem is a bit different in
>>>> that pinctrl is more likely entirely optional while clocks are often
>>>> required. You may do all pin setup in bootloader/firmware on some
>>>> boards and not others. Of course then why put pinctrl in the DT in
>>>> that case? They could be present just due to how chip vs. board dts
>>>> files are structured.
>>>
>>>
>>> I see. My instinct tells me that it would be better if the gpio-ranges
>>> property was set in the board dts, but I don't really know what each
>>> mach does with its DTSs.
>>
>>
>> That doesn't make sense; the mapping between GPIO controller pins and pin
>> controller pins is a property of the SoC not the board.
>
> From what Rob said above, apparently some boards will rely on the pin
> setup done by the bootloader, and some other boards with the same soc
> will want to do it in the kernel. So it's not really a difference in
> the hw itself, but what expectations exist about the firmware on a
> specific board.

Sure, but none of that changes the mapping between the GPIO and pin
controller pins.



\
 
 \ /
  Last update: 2015-07-10 19:21    [W:0.099 / U:0.304 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site