lkml.org 
[lkml]   [2015]   [Jun]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 4/8] input: goodix: reset device at init
From
Date
On Tue, 2015-06-09 at 17:34 +0200, Bastien Nocera wrote:
> On Mon, 2015-06-08 at 17:37 +0300, Irina Tirdea wrote:
> > After power on, it is recommended that the driver resets the
> > device.
> > The reset procedure timing is described in the datasheet and is
> > used
> > at device init (before writing device configuration) and
> > for power management. It is a sequence of setting the interrupt
> > and reset pins high/low at specific timing intervals. This
> > procedure
> > also includes setting the slave address to the one specified in the
> > ACPI/device tree.
>
> This breaks the touchscreen on my Onda v975w:
> [ 239.732858] Goodix-TS i2c-GDIX1001:00: ID 9271, version: 1020
> [ 239.732977] Goodix-TS i2c-GDIX1001:00: Failed to get reset GPIO:
> -16
> [ 239.736071] Goodix-TS: probe of i2c-GDIX1001:00 failed with error
> -16
>
> This is the DSDT for that device:
> https://bugzilla.kernel.org/attachment.cgi?id=149331

(Note that this means that I haven't been able to test any following
patches in that series than 4/8).


\
 
 \ /
  Last update: 2015-06-09 18:21    [W:0.117 / U:2.700 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site