lkml.org 
[lkml]   [2015]   [Jun]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 1/2] dt-bindings: mediatek: Add MT8173 cpufreq driver binding
From
Hi Mike,

On Tue, Jun 30, 2015 at 5:53 AM, Michael Turquette
<mturquette@baylibre.com> wrote:
> Quoting Viresh Kumar (2015-06-23 18:06:21)
>> Adding Mike's new email address..
>>
>> On 23-06-15, 23:31, Pi-Cheng Chen wrote:
>> > On Mon, Jun 8, 2015 at 8:29 PM, Pi-Cheng Chen <pi-cheng.chen@linaro.org> wrote:
>> > > This patch adds device tree binding document for MT8173 cpufreq driver.
>> > >
>> > > Signed-off-by: Pi-Cheng Chen <pi-cheng.chen@linaro.org>
>> > > ---
>> > > .../devicetree/bindings/cpufreq/cpufreq-mt8173.txt | 127 +++++++++++++++++++++
>> > > 1 file changed, 127 insertions(+)
>> > > create mode 100644 Documentation/devicetree/bindings/cpufreq/cpufreq-mt8173.txt
>> > >
>> > > diff --git a/Documentation/devicetree/bindings/cpufreq/cpufreq-mt8173.txt b/Documentation/devicetree/bindings/cpufreq/cpufreq-mt8173.txt
>> > > new file mode 100644
>> > > index 0000000..7708a65
>> > > --- /dev/null
>> > > +++ b/Documentation/devicetree/bindings/cpufreq/cpufreq-mt8173.txt
>> > > @@ -0,0 +1,127 @@
>> > > +
>> > > +Mediatek MT8173 cpufreq driver
>> > > +-------------------
>>
>> Few more ---- required.
>>
>> > > +
>> > > +Mediatek MT8173 cpufreq driver for CPU frequency scaling.
>> > > +
>> > > +Required properties:
>> > > +- clocks: A list of phandle + clock-specifier pairs for the clocks listed in clock names.
>> > > +- clock-names: Should contain the following:
>> > > + "cpu" - The multiplexer for clock input of CPU cluster.
>> > > + "intermediate" - A parent of "cpu" clock which is used as "intermediate" clock
>> > > + source (usually MAINPLL) when the original CPU PLL is under
>> > > + transition and not stable yet.
>>
>> These belong to Mike.
>
> Everything looks good. This is a typical clock consumer based on the
> generic clock-binding. You might want to reference that this cpufreq
> binding uses the "Clock consumers" portion of the clock binding and
> reference its location:
>
> Documentation/devicetree/bindings/clock/clock-bindings.txt

I will add it.

>
> Please add,
>
> Reviewed-by: Michael Turquette <mturquette@baylibre.com>

Thanks for reviewing.

Pi-Cheng

>
> Thanks,
> Mike
>
>>
>> > > +- operating-points: Table of frequencies and voltage CPU could be transitioned into,
>> > > + Frequency should be in KHz units and voltage should be in microvolts.
>>
>> That's not complete. You should just mention the path to opp bindings
>> here. And that's it.
>>
>> > > +- proc-supply: Regulator for Vproc of CPU cluster.
>> > > +
>> > > +Optional properties:
>> > > +- sram-supply: Regulator for Vsram of CPU cluster. When present, the cpufreq driver
>> > > + needs to do "voltage trace" to step by step scale up/down Vproc and
>> > > + Vsram to fit SoC specific needs. When absent, the voltage scaling
>> > > + flow is handled by hardware, hence no software "voltage trace" is
>> > > + needed.
>> > > +
>> > > +Example:
>> > > +--------
>> > > + cpu0: cpu@0 {
>> > > + device_type = "cpu";
>> > > + compatible = "arm,cortex-a53";
>> > > + reg = <0x000>;
>> > > + enable-method = "psci";
>> > > + cpu-idle-states = <&CPU_SLEEP_0>;
>> > > + clocks = <&infracfg CLK_INFRA_CA53SEL>,
>> > > + <&apmixedsys CLK_APMIXED_MAINPLL>;
>> > > + clock-names = "cpu", "intermediate";
>> > > + operating-points = <
>> > > + 507000 859000
>> > > + 702000 908000
>> > > + 1001000 983000
>> > > + 1105000 1009000
>> > > + 1183000 1028000
>> > > + 1404000 1083000
>> > > + 1508000 1109000
>> > > + 1573000 1125000
>> > > + >;
>> > > + };
>> > > +
>> > > + cpu1: cpu@1 {
>> > > + device_type = "cpu";
>> > > + compatible = "arm,cortex-a53";
>> > > + reg = <0x001>;
>> > > + enable-method = "psci";
>> > > + cpu-idle-states = <&CPU_SLEEP_0>;
>> > > + clocks = <&infracfg CLK_INFRA_CA53SEL>,
>> > > + <&apmixedsys CLK_APMIXED_MAINPLL>;
>> > > + clock-names = "cpu", "intermediate";
>> > > + operating-points = <
>> > > + 507000 859000
>> > > + 702000 908000
>> > > + 1001000 983000
>> > > + 1105000 1009000
>> > > + 1183000 1028000
>> > > + 1404000 1083000
>> > > + 1508000 1109000
>> > > + 1573000 1125000
>> > > + >;
>> > > + };
>> > > +
>> > > + cpu2: cpu@100 {
>> > > + device_type = "cpu";
>> > > + compatible = "arm,cortex-a57";
>> > > + reg = <0x100>;
>> > > + enable-method = "psci";
>> > > + cpu-idle-states = <&CPU_SLEEP_0>;
>> > > + clocks = <&infracfg CLK_INFRA_CA57SEL>,
>> > > + <&apmixedsys CLK_APMIXED_MAINPLL>;
>> > > + clock-names = "cpu", "intermediate";
>> > > + operating-points = <
>> > > + 507000 828000
>> > > + 702000 867000
>> > > + 1001000 927000
>> > > + 1209000 968000
>> > > + 1404000 1007000
>> > > + 1612000 1049000
>> > > + 1807000 1089000
>> > > + 1989000 1125000
>> > > + >;
>> > > + };
>> > > +
>> > > + cpu3: cpu@101 {
>> > > + device_type = "cpu";
>> > > + compatible = "arm,cortex-a57";
>> > > + reg = <0x101>;
>> > > + enable-method = "psci";
>> > > + cpu-idle-states = <&CPU_SLEEP_0>;
>> > > + clocks = <&infracfg CLK_INFRA_CA57SEL>,
>> > > + <&apmixedsys CLK_APMIXED_MAINPLL>;
>> > > + clock-names = "cpu", "intermediate";
>> > > + operating-points = <
>> > > + 507000 828000
>> > > + 702000 867000
>> > > + 1001000 927000
>> > > + 1209000 968000
>> > > + 1404000 1007000
>> > > + 1612000 1049000
>> > > + 1807000 1089000
>> > > + 1989000 1125000
>> > > + >;
>> > > + };
>>
>> I remember Mark Rutland asking you about the replicated stuff for all
>> CPUs, but happened to his comments later on ? Were you asked to put
>> these for all the CPUs ?
>>
>> --
>> viresh


\
 
 \ /
  Last update: 2015-07-01 04:21    [W:0.077 / U:0.144 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site