lkml.org 
[lkml]   [2015]   [Jun]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 0/7] soc: brcmstb: add system suspend support for STB SoCs
On Thu, Jun 18, 2015 at 5:11 PM, Brian Norris
<computersforpeace@gmail.com> wrote:
> Hi,
>
> This patch set introduces system suspend/resume support for Broadcom STB SoCs.
> There are two suspend modes (S2 and S3) as well as a related low-power shutdown
> mode (S5).
>
> Along with the core PM support, include a driver for the wakeup-timer, which
> allows for simple testing of suspend/resume wakeup cycles.
>
> Brian
>
> Brian Norris (7):
> Documentation: dt: brcmstb: add system PM bindings
> Documentation: dt: brcmstb: add waketimer documentation
> soc: add stubs for brcmstb SoC's
> soc: brcmstb: add PM suspend/resume support (S2/S3/S5)
> soc: brcmstb: add wake-timer driver
> ARM: brcmstb: mask GIC IRQs on suspend
> ARM: dts: brcmstb: add BCM7445 system PM DT nodes
>

I tested this series two ways: with the device tree built into the
bootloader (BOLT) on BCM7445 and by using
arch/arm/boot/dts/bcm7445-bcm97445svmb.dtb

With the device tree from BOLT, everything works fine. Tested the
waketimer for S2, S3, and S5.

With the device tree in arch/arm/boot/dts/bcm7445-bcm97445svmb.dts, S2
works, but S3 and S5 do not. It comes back up but doesn't reach the
prompt:

[ 6.050808] PM: suspend of devices complete after 1.425 msecs
[ 6.051760] PM: late suspend of devices complete after 0.947 msecs
[ 6.052535] PM: noirq suspend of devices complete after 0.770 msecs
[ 6.052537] Disabling non-boot CPUs ...
[ 6.053005] CPU1: shutdown
[ 6.065914] CPU2: shutdown
[ 6.080756] CPU3: shutdown
[ 6.095214] Enabling non-boot CPUs ...
[ 6.111496] CPU1 is up
[ 6.126934] CPU2 is up
[ 6.142511] CPU3 is up
[ 6.145308] PM: noirq resume of devices complete after 2.772 msecs
[ 6.148022] PM: early resume of devices complete after 2.626 msecs
[ 6.151017] PM: resume of devices complete after 2.976 msecs
[ 6.212771] Restarting tasks ... done.
[[[ output stops here ]]]

I suspect there might be an issue somewhere in
[PATCH 7/7] ARM: dts: brcmstb: add BCM7445 system PM DT nodes.


\
 
 \ /
  Last update: 2015-06-19 05:41    [W:0.247 / U:0.328 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site