lkml.org 
[lkml]   [2015]   [Jun]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] drm: bridge/dw_hdmi: Filter modes > 165MHz for DVI
On Wed, Jun 17, 2015 at 04:14:07PM -0700, Doug Anderson wrote:
> If you plug in a DVI monitor to your HDMI port, you need to filter out
> clocks > 165MHz. That's because 165MHz is the maximum clock rate that
> we can run single-link DVI at.
>
> If you want to run high resolutions to DVI, you'd need some type of an
> active adapter that pretended that it was HDMI, interpreted the
> signal, and produced a new dual link DVI signal at a lower clock rate.
>
> Signed-off-by: Doug Anderson <dianders@chromium.org>
> ---
> Note: this patch was tested against a 3.14 kernel with backports. It
> was only compile tested against linuxnext, but the code is
> sufficiently similar that I'm convinced it will work there.

Really? I have to wonder what your testing was...

hdmi->vic = drm_match_cea_mode(mode);

if (!hdmi->vic) {
dev_dbg(hdmi->dev, "Non-CEA mode used in HDMI\n");
hdmi->hdmi_data.video_mode.mdvi = true;
} else {
dev_dbg(hdmi->dev, "CEA mode used vic=%d\n", hdmi->vic);
hdmi->hdmi_data.video_mode.mdvi = false;
}

mdvi indicates whether the _currently set mode_ is a CEA mode or not (imho,
it's mis-named). It doesn't indicate whether we have a HDMI display device
or a DVI display device connected, which seems to be what you want to use
it for below.

To sort that, what you need to do is detect a HDMI display device using
drm_detect_hdmi_monitor() on the EDID received from the device before
parsing the modes, and save that value in a dw_hdmi struct member, and
I'd suggest that it's a top-level struct member, not buried in 'hdmi_data'
or 'video_mode'.

--
FTTC broadband for 0.8mile line: currently at 10.5Mbps down 400kbps up
according to speedtest.net.


\
 
 \ /
  Last update: 2015-06-18 01:41    [W:0.052 / U:2.084 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site