lkml.org 
[lkml]   [2015]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: Why isn't IRQ shared for i2c-ocore
From
On Fri, May 8, 2015 at 8:57 AM, Lee Jones <lee.jones@linaro.org> wrote:
> On Fri, 08 May 2015, Geert Uytterhoeven wrote:
>
>> On Thu, May 7, 2015 at 9:01 AM, Lee Jones <lee.jones@linaro.org> wrote:
>> >> I have a follow up question regarding interrupt. I see many I2C bus drivers
>> >> request interrupt with flag = 0. Why not using IRQF_SHARED?
>> >
>> > Probably because that particular IRQ is only used by the I2C
>> > Controller. I'm not exactly sure that you're getting at? Why do you
>> > think it should be shared? You should only flag it as shared if it
>> > is.
>>
>> However, that's something the driver can't know.
>> Sharing interrupts is an integration property. The same IP core may share its
>> interrupt on one SoC, and not on another.
>
> I guess that would depend on the IP. If this is part of an MFD, you'd
> know if you only hand a single interrupt line coming into the chip or
> not. If the IP can be moved around (copy & pasted) into different
> chips, then yes, that might change.
>
> How does one share an interrupt with other drivers if all them don't
> know the IRQ is shared thought?

All drivers sharing the same interrupt must pass IRQF_SHARED, cfr. the
checks in __setup_irq().

Traditionally, PC (ISA) drivers didn't share interrupts, as the ISA bus
prohibited interrupt sharing.
Amiga drivers did.

New drivers should support IRQ sharing.

Gr{oetje,eeting}s,

Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds


\
 
 \ /
  Last update: 2015-05-08 09:21    [W:0.035 / U:0.756 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site