lkml.org 
[lkml]   [2015]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] Input: Add generic driver for Zeitec touchscreens
Hi Bogdan,

On Thu, May 28, 2015 at 03:22:02PM +0300, Bogdan George Stefan wrote:
> This driver adds support for Zeitec touchscreens. It has
> been tested with ZET6273 and ZET9172.
>
> It supports ACPI and device tree enumeration. For ACPI you need ACPI
> 5.1+ in order to be able to use named GPIOs.
>
> Screen resolution, the maximum number of fingers supported,
> if the touchscreen has hardware keys are configurable
> using ACPI/DT properties.
>
> Signed-off-by: Bogdan George Stefan <bogdan.g.stefan@intel.com>
> ---
> Changes since v1:
>
> Implemented most changes following Dmitry Torokhov's recommendations
> from https://lkml.org/lkml/2015/5/15/319
> The only things I kept are described below in the Notes section.
> - fixed style issues
> - reset is activated when gpio is set to high
> - switched from i2c_transfer to i2c_master_recv/i2c_master_send
> - removed redundant evbit initialization. However EV_ABS still needs
> to be reported and it is set through input_set_capability
> - replaced usleep_range with msleep where neede. Checking the patch
> with -strict will report an issue on this. Hope this is not a problem
> - fixed casts in zet_process_events
> - removed client->irq = gpiod_to_irq(ts->irq); from probe
> - moved firmware loading from probe to open
> - used proper casts in zet_suspend
> - dropped zet_ts_remove as it was doing unnecesary things
> Notes:
> - I've kept the flags IRQF_TRIGGER_FALLING | IRQF_ONESHOT when calling
> devm_request_threaded_irq. No the irq handler is not called whn only IRQF_ONESHOT
> is used. Looking at other drivers, I saw that they use the same aproach. I am not
> sure how to setup things in ACPI/DT so that the driver could work only with IRQF_ONESHOT

Hmm, Rafael, do ACPI systems automatically set up IRQ triggers,
similarly to what OF systems do (based on device tree data)?

> - The number of thingers that can simultaneously touch the device and if it has
> HW keys or not, cannot be read from the device. I've asked Zeitec on this.

According to a random Zeitec datasheet I found on the web you send 0xB2
command to the device to retrieve buch of information, including number
of fingers and whether keys are supported.

Thanks.

--
Dmitry


\
 
 \ /
  Last update: 2015-05-30 02:41    [W:1.253 / U:0.104 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site