Messages in this thread Patch in this message | | | From | Paul Burton <> | Subject | [PATCH 08/15] of_serial: support for UARTs on I/O ports | Date | Fri, 22 May 2015 16:51:07 +0100 |
| |
If the address provided for the UART is of an I/O port rather than a regular memory address, then set the port iotype appropriately and write the address to iobase rather than mapbase.
Signed-off-by: Paul Burton <paul.burton@imgtec.com> ---
drivers/tty/serial/of_serial.c | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/drivers/tty/serial/of_serial.c b/drivers/tty/serial/of_serial.c index 137381e..ccff9ba 100644 --- a/drivers/tty/serial/of_serial.c +++ b/drivers/tty/serial/of_serial.c @@ -110,7 +110,12 @@ static int of_platform_serial_setup(struct platform_device *ofdev, port->irq = irq_of_parse_and_map(np, 0); port->iotype = UPIO_MEM; - if (of_property_read_u32(np, "reg-io-width", &prop) == 0) { + + if (resource.flags & IORESOURCE_IO) { + port->iotype = UPIO_PORT; + port->iobase = port->mapbase; + port->mapbase = 0; + } else if (of_property_read_u32(np, "reg-io-width", &prop) == 0) { switch (prop) { case 1: port->iotype = UPIO_MEM; -- 2.4.1
| |