Messages in this thread | | | Date | Wed, 20 May 2015 11:09:08 -0300 | From | Ezequiel Garcia <> | Subject | Re: [PATCH v5 07/12] mtd: nand: add Samsung K9GBG08U0A-M to nand_ids table |
| |
On 05/20/2015 11:06 AM, Antoine Tenart wrote: > On Sat, May 16, 2015 at 03:57:00PM -0300, Ezequiel Garcia wrote: >> On 05/11/2015 11:58 AM, Antoine Tenart wrote: >>> Add the full description of the Samsung K9GBG08U0A-M nand chip in the >>> nand_ids table. >>> >>> Signed-off-by: Antoine Tenart <antoine.tenart@free-electrons.com> >>> --- >>> drivers/mtd/nand/nand_ids.c | 4 ++++ >>> 1 file changed, 4 insertions(+) >>> >>> diff --git a/drivers/mtd/nand/nand_ids.c b/drivers/mtd/nand/nand_ids.c >>> index dd620c19c619..500c33e1db06 100644 >>> --- a/drivers/mtd/nand/nand_ids.c >>> +++ b/drivers/mtd/nand/nand_ids.c >>> @@ -50,6 +50,10 @@ struct nand_flash_dev nand_flash_ids[] = { >>> { .id = {0xad, 0xde, 0x94, 0xda, 0x74, 0xc4} }, >>> SZ_8K, SZ_8K, SZ_2M, 0, 6, 640, NAND_ECC_INFO(40, SZ_1K), >>> 4 }, >>> + {"NAND 4GiB 3,3V 8-bit", >>> + { .id = {0xec, 0xd7, 0x94, 0x76, 0x64, 0x43}, }, >>> + 8192, 4096, SZ_1M, LP_OPTIONS, 0, 0, NAND_ECC_INFO(40, SZ_1K), >> >> You should stick to SZ_8K and SZ_4K here. > > Right. > >> >>> + 4 }, >>> >>> LEGACY_ID_NAND("NAND 4MiB 5V 8-bit", 0x6B, 4, SZ_8K, SP_OPTIONS), >>> LEGACY_ID_NAND("NAND 4MiB 3,3V 8-bit", 0xE3, 4, SZ_8K, SP_OPTIONS), >>> >> >> I found a datasheet here for K9GBG08U0A that claims to support JEDEC >> device identification (i.e. 0x90 0x40 and 0xEC 0x40 commands). Have you >> tested it? Any reason you are adding full ID instead? > > This nand looks like another one defined in this file, so a full ID make > sure the right parameters applies here. >
Oh, so you say the NAND detects the device ID and uses those parameters, instead of doing the JEDEC detection?
Then I'd say NAND is broken and should be fixed. Brian, am I crazy? -- Ezequiel Garcia, VanguardiaSur www.vanguardiasur.com.ar
| |