lkml.org 
[lkml]   [2015]   [May]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 1/4] mailbox: add support for System Control and Power Interface(SCPI) protocol
From
On Wed, May 13, 2015 at 10:39 PM, Sudeep Holla <sudeep.holla@arm.com> wrote:
> On 13/05/15 17:52, Jassi Brar wrote:
>>
>>> This patch adds support for System Control and Power Interface (SCPI)
>>> Message Protocol used between the Application Cores(AP) and the System
>>> Control Processor(SCP). The MHU peripheral provides a mechanism for
>>> inter-processor communication between SCP's M3 processor and AP.
>>>
>>> SCP offers control and management of the core/cluster power states,
>>> various power domain DVFS including the core/cluster, certain system
>>> clocks configuration, thermal sensors and many others.
>>>
>>> This protocol driver provides interface for all the client drivers using
>>> SCPI to make use of the features offered by the SCP.
>>>
>> Is the SCPI specification available somewhere to look into?
>>
>
> Yes sorry posted the link separately(as reply to Tixy in the cover
> letter) since it was not available when I posted the patches.
> You can grab the protocol @[1] or [2]
>
Thanks for the link. I wish I had access to the spec earlier.

>>> .../devicetree/bindings/mailbox/arm,scpi.txt | 121 ++++
>>> drivers/mailbox/Kconfig | 19 +
>>> drivers/mailbox/Makefile | 2 +
>>> drivers/mailbox/scpi_protocol.c | 694
>>> +++++++++++++++++++++
>>>
>> Why in drivers/mailbox/ ? This is a 'consumer' driver and seems
>> Juno(ARM) specific.
>>
>
> Not just JUNO alone though it's first one to use, it will used in next
> few platforms(foreseeable future) from ARM Ltd.
>
> I have put that in drivers/mailbox for 2 reasons:
> 1. It's mailbox protocol :)
>
client/protocol drivers don't usually reside with controller drivers.
drivers/firmware/ seems more appropriate.

> 2. ARM64 doesn't have platform code like ARM32 and moreover it's
> strictly not specific to JUNO or any single platform. It may
> get reused on other platforms.
>
drivers/firmware/ should do too.

BTW is scpi_protocol.c meant/tested to work over arm_mhu.c? The spec
says so but I don't see how because you pass 'struct scpi_xfer*' as
the message whereas arm_mhu.c expects u32*


\
 
 \ /
  Last update: 2015-05-14 09:41    [W:0.118 / U:0.580 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site