lkml.org 
[lkml]   [2015]   [Apr]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    Subject[PATCH V7 0/9] Tegra xHCI support
    Date
    This series adds support for xHCI on NVIDIA Tegra SoCs.  This includes:
    - patches 1, 2, and 3: minor cleanups for mailbox framework and xHCI,
    - patches 4 and 5: adding an MFD driver for the XUSB cmoplex,
    - patches 6 and 7: adding a driver for the mailbox used to communicate
    with the xHCI controller's firmware, and
    - patches 8 and 9: adding a xHCI host-controller driver.

    The addition of USB PHY support to the XUSB padctl driver has been dropped
    from v7. Thierry will be posting those patches later.

    Given the many compile and run-time dependencies in this series, it is probably
    best if the first 3 patches are picked up by the relevant maintainers in topic
    branches so that the remainder of the series can go through the Tegra tree.

    Tested on Jetson TK1 and Nyan-Big with a variety of USB2.0 and USB3.0 memory
    sticks and ethernet dongles. This has also been tested, with additional
    out-of-tree patches, on a Tegra132-based board.

    Based on v4.1-rc1. A branch with the entire series is available at:
    https://github.com/abrestic/linux/tree/tegra-xhci-v7

    Changes from v6:
    - Dropped PHY changes from series. Will be posted later by Thierry.
    - Added an MFD device with the mailbox and xHCI host as sub-devices.

    Changes from v5:
    - Addressed review comments from Jassi and Felipe.

    Changes from v4:
    - Made USB support optional in padctl driver.
    - Made usb3-port a pinconfig property again.
    - Cleaned up mbox_request_channel() error handling and allowed it to defer
    probing (patch 3).
    - Minor xHCI (patch 1) and mailbox framework (patch 2) cleanups suggested
    by Thierry.
    - Addressed Thierry's review comments.

    Changes from v3:
    - Fixed USB2.0 flakiness on Jetson-TK1.
    - Switched to 32-bit DMA mask for host.
    - Addressed Stephen's review comments.

    Chagnes from v2:
    - Dropped mailbox channel specifier. The mailbox driver allocates virtual
    channels backed by the single physical channel.
    - Added support for HS_CURR_LEVEL adjustment pinconfig property, which
    will be required for the Blaze board.
    - Addressed Stephen's review comments.

    Changes from v1:
    - Converted mailbox driver to use the common mailbox framework.
    - Fixed up host driver so that it can now be built and used as a module.
    - Addressed Stephen's review comments.
    - Misc. cleanups.

    Andrew Bresticker (8):
    xhci: Set shared HCD's hcd_priv in xhci_gen_setup
    mailbox: Make struct mbox_controller's ops field const
    mfd: Add binding document for NVIDIA Tegra XUSB
    mfd: Add driver for NVIDIA Tegra XUSB
    mailbox: Add NVIDIA Tegra XUSB mailbox binding
    mailbox: Add NVIDIA Tegra XUSB mailbox driver
    usb: Add NVIDIA Tegra xHCI controller binding
    usb: xhci: Add NVIDIA Tegra xHCI host-controller driver

    Benson Leung (1):
    mailbox: Fix up error handling in mbox_request_channel()

    .../bindings/mailbox/nvidia,tegra124-xusb-mbox.txt | 30 +
    .../bindings/mfd/nvidia,tegra124-xusb.txt | 46 +
    .../bindings/usb/nvidia,tegra124-xhci.txt | 90 ++
    drivers/mailbox/Kconfig | 8 +
    drivers/mailbox/Makefile | 2 +
    drivers/mailbox/mailbox.c | 11 +-
    drivers/mailbox/omap-mailbox.c | 6 +-
    drivers/mailbox/tegra-xusb-mailbox.c | 275 ++++++
    drivers/mfd/Kconfig | 7 +
    drivers/mfd/Makefile | 1 +
    drivers/mfd/tegra-xusb.c | 167 ++++
    drivers/usb/host/Kconfig | 10 +
    drivers/usb/host/Makefile | 1 +
    drivers/usb/host/xhci-pci.c | 5 -
    drivers/usb/host/xhci-plat.c | 5 -
    drivers/usb/host/xhci-tegra.c | 946 +++++++++++++++++++++
    drivers/usb/host/xhci.c | 6 +-
    include/linux/mailbox_controller.h | 2 +-
    include/soc/tegra/xusb.h | 49 ++
    19 files changed, 1647 insertions(+), 20 deletions(-)
    create mode 100644 Documentation/devicetree/bindings/mailbox/nvidia,tegra124-xusb-mbox.txt
    create mode 100644 Documentation/devicetree/bindings/mfd/nvidia,tegra124-xusb.txt
    create mode 100644 Documentation/devicetree/bindings/usb/nvidia,tegra124-xhci.txt
    create mode 100644 drivers/mailbox/tegra-xusb-mailbox.c
    create mode 100644 drivers/mfd/tegra-xusb.c
    create mode 100644 drivers/usb/host/xhci-tegra.c
    create mode 100644 include/soc/tegra/xusb.h

    --
    2.2.0.rc0.207.ga3a616c



    \
     
     \ /
      Last update: 2015-04-28 01:01    [W:3.154 / U:0.076 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site